Model #11076860100 KENMORE Residential Dryer

  • Top And Console Assembly
    3 Results
  • Cabinet Assembly
    3 Results
  • Bulkhead Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do I replace the belt on my Kenmore dryer?

A:

With the drum out slip the belt around the drum flat side facing up. Use the belt to lift the drum & set it in position on the rear rollers. Use a wooden block to level up the front of the drum. You will need both hands free to put the belt on. With the drum supported route the belt around the motor & idler pulleys as shown in the image provided below. Once you have the belt in position remove the wooden blocks & install the front panel. Once the front is secured rotate the drum manually counterclockwise to align the belt.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
biker dave -
Sears Technician
April 01, 2010
Q:

Why will my dryer run great for one cycle then won't restart until it cools down?

A:

Due to the age of the dryer, the most likely failure is a bad motor, or the motor is covered in lint or you have a severe friction problem. The motor is getting hot and shutting off by the internal thermal overload and it will not start again until the motor cools and the overload resets.

I recommend opening the door and reach into the empty drum and manually rotate it counterclockwise (CCW) to see how much resistance there is. It should require some effort to get the drum turning but once you have it rotating it should not require too much force to keep it rotating if there's not a friction issue.

Read More
Joey S -
Sears Technician
February 13, 2009

Top Parts