Model #11076752500 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
  • 8318272 Burner Assembly, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Igniter? 11076752500 Kenmore Dryer

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help you. Upon researching model 11076752500 I found our video for replacing it.

Click here for link.

If you have any further questions please re-post question. Thank you for choosing Sears. Have a great day.

Read More
Samantha A -
Sears Technician
June 03, 2014
Q:

Gas Dryer will heat at start but will not as cycle goes on.

A:

I am sorry that you are having some difficulties with your dryer and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your dryer troubles while you wait for your expert response.

Read More
Joseph P. -
October 15, 2012
A:

The key to this problem is knowing what the ignitor is doing. There is a small square plug on the left side of the front panel that can be removed so you can visually check if the ignitor is glowing. If the ignitor continues to glow and click off but there is no flame then I suspect the gas coils or valve is at fault. If the ignitor is glowing but not clicking off then I suspect the radiant sensor is the problem. It is difficult to determine if the coils or valve is at fault since it does work for a short time. Check what the ignitor is doing and reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
October 16, 2012
See more answers
Q:

SEARS DRYER WILL HEAT AT START OF CYCLE BUT AS IT GOES ON

A:

I am sorry that you are having some difficulties with your dryer and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. The expert will respond within 24 to 48 hours. Thank you for your patience!

Read More
Joseph P. -
October 15, 2012
A:

The key to this problem is knowing what the ignitor is doing. There is a small square plug on the left side of the front panel that can be removed so you can visually check if the ignitor is glowing. If the ignitor continues to glow and click off but there is no flame then I suspect the gas coils or valve is at fault. If the ignitor is glowing but not clicking off then I suspect the radiant sensor is the problem. It is difficult to determine if the coils or valve is at fault since it does work for a short time. Check what the ignitor is doing and reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
October 16, 2012
See more answers

Top Parts