Model #11076722690 KENMORE Residential Dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Natural gas smell to clothing (Occassionally) 11076722690 Kenmore Electric dryer

Q:

Kenmore series 7 gas dryer won't start

A:

I understand that your dryer will not start. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. Have a great day!

Read More
Alina F. -
May 19, 2012
A:

Thank you for your question and I understand your concern.

The first thing to check is wall out. Make sure the outlet is working by plugging in a hair dryer or some other electrical device. If the outlet works; the failure could be the timer, motor, push to start switch or a faulty door switch.

I added an image below of the wiring diagram. I traced the electrical motor circuit red, blue and black. In order to diagnose the failure will require a volt/Ohm meter. The timer contact BK to BU will need to be tested for continuity, the door switch and the push to start switch. The wires from the component being tested for continuity must be disconnected from the component before measuring across the terminals for continuity with the Ohm meter.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
May 21, 2012
See more answers
Q:

Model 110.76722690 gas dryer runs, but does not heat.

A:

The dryer makes live much more convenient. The dryer not heating can be problematic. I did find some information for you that I am really hoping will help you with the dryer. I am adding the links below to help you with your question while you wait for your expert response. I do hope that this will help you out.

Read More
Marc H -
May 14, 2012
A:

Thank you for your question and I understand your concern.

There is a good chance the thermal fuse is faulty or possibly a broken igniter if the igniter is not glowing. If the igniter will glow and fade off without burner ignition the likely problem is weak solenoid coils on the gas valve.

I added an image below of the wiring diagram. I traced the heating circuit in red and green. This circuit and the components in the circuit must have continuity in order to complete the circuit to the gas valve, igniter and flame sensor.

You can pry the small square inspection cover off located below the door and watch to see if the glow bar igniter will glow or not. If it does not glow, the thermal fuse and igniter should be disconnected and measured for continuity using an Ohm meter. I recommend checking the thermal fuse first. The thermal fuse is located at the back of the dryer. Disconnect the power cord from the power source before removing the rear panel. The thermal fuse is located on the blower wheel housing.

To access the igniter and solenoid coils; the front panel will need to be removed.

I added a YouTube video showing how to test the thermal fuse. I added another YouTube video showing how to access and replace the glow bar igniter .

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
May 15, 2012
See more answers

Top Parts