Model #11076712691 KENMORE Residential Dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore 70 Series Gas Dryer not Heating 11076712691 Kenmore Gas dryer

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Kenmore dryer.

From the information you have provided above, I can see how frustrating it can be to have your dryer because some issues, but after researching model number 110.76712691. It could be a couple parts that may be causing the dryer not to be heating. I would suggest checking to see if the ignitor/glow bar is turning on. this is heat ignites the heat for the dryer. The other part will be the gas valve. The gas may not be getting to the ignitor to kick on the heat. Lastly, the heater coils may have gone out. If you would feel more comfortable having a technician diagnose the issue you can set up service at 1-800-4MY-HOME.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

Read More
Benny23 -
Sears Technician
February 24, 2015
Q:

why is my kenmore gas dryer(11076712691) still no heating up after installing a new ignighter???

A:

I'm sorry that you are having some difficulties with your Kenmore gas dryer. Managemylife.com is a great web site to receive expert assistance to just about everything. I did some research for you there and found an expert answer to a similar question that may shed some light on this problem. I have attached the link below. If you decide you would like to schedule service from a qualified technician I have also attached a link to searshomeservices.com. I hope theses links will be helpful until your expert can respond.

Read More
James -
April 02, 2011
A:

Thank you for your question and I understand your concern.

I added a couple of images below with the wiring diagram and parts diagram to reference the key numbers and part location. NOTE: Disconnect the power cord from the power source before removing the rear panel.

The igniter is not likely glowing because it's not getting voltage. In order for the igniter to receive voltage the following components must have continuity:

  • High limit thermostat (key#34)
  • Operating thermostat (key#41)
  • Thermal fuse (key#39)
  • Flame sensor (key#9)

Each one of the components I mentioned above can be accessed by removing the rear panel. Each one will need to be disconnected and tested with an ohm meter for continuity. I added a Youtube video showing how to test the thermal fuse which also applies to the other components too. Click here for video.

Whichever one tests open/no continuity, replace that component. Parts can be looked up and ordered from Sears PartsDirect

Read More
Joey S -
Sears Technician
April 04, 2011
See more answers

Top Parts