Model #11074872400 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts And Optional Parts (not Included)
    3 Results
  • 8318276 Burner Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore Dryer Model #11074872400 Only turns on in Air Fluff 11074872400

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Kenmore dryer.

From the information you have provided above, I can understand the frustration of having your dryer malfunction, after researching model number 110.74872400. if the fuse is blown it will allow the dryer to work on air fluff. The fuse is what allows the dryer to heat up. I would suggest replacing the fuse to start with to see if that fixes the issue.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

*Safety disclaimer before you try and repair the unit make sure the power supply is disconnected. There may be sharp parts to the unit that can cause injury to you if not careful. If you don’t not feel comfortable checking this yourself you can request a technician by visiting www.SearsHomeService.com*

Read More
Benny23 -
Sears Technician
May 22, 2015
A:

Thanks for the reply, I took the fuse out and used an ohm meter to test it and it seems to be good, could it be the thermostat ?

Read More
Mike -
May 22, 2015
See more answers
Q:

dryer not heating 11074872400 Kenmore Residential dryer

A:

Thank you for choosing SearsPartsDirect.com and being a valued member.  I can certainly understand how frustrating it can be when your dryer no longer heats.

 
If the high limit or operating thermostat is open, the ignitor will not glow. I recommend checking the 2 thermostats with a multimeter. The thermostat that checks open is bad and needs to be replaced.

On a gas dryer an open thermal fuse will allow the dryer to run but not to heat.

The igniter can be checked with a volt/ohm meter the same way the thermal fuse can be checked. You can check for continuity across the thermostat and thermistor. If the circuit is open then that part needs to be replaced. The igniter should ohm out between 50 and 500 ohms.




You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day. 

Read More
Natasha12 -
Sears Technician
December 12, 2014
Q:

Dryer vent solution 11074872400 Kenmore Residential dryer


Top Parts