Model #11074632300 KENMORE Residential Dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
  • Burner Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Not drying 11074632300 Kenmore Gas dryer

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your dryer. Upon researching model 11074632300; there could be a couple things preventing the igniter from turning on. I linked the wiring diagram below so you could see the parts in line. Check the high limit thermostat, thermal cutoff, operating thermostat and the thermal fuse.

Thank you for choosing Sears. We appreciate your business. Have a great day.

Read More
Jeff Wallace Jr -
Sears Technician
December 02, 2014
Q:

Repairs on my Kenmore gas dryer.

A:

Managemylife.com is a great place to find the answers to just about anything, especially on appliances. I admire that you are willing to take on a repair like this one. I found this expert answer that is attached below in a link to assist you. I hope this will help until your expert responds to your question.

Read More
James -
April 14, 2012
A:

The image below will show how to raise the top and remove the front panel to access the drum. Remember to unplug the dryer first.

Read More
Fred M -
Sears Technician
April 14, 2012
See more answers
Q:

Kenmore dryer not working correctly

A:

I'm sorry to hear that you are having some difficulties with your dryer. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
Jackie S -
January 09, 2012
A:

I know how frustrating it is to have your dryer stop working correctly. Since you don't state that the dryer is heating, I assume that it's not. There are several components other than the thermal fuse that can cause this problem. They are the ignitor (you should be able to see this glowing), the thermostat, the thermistor, the thermal cut-off, the coils and the burner assembly. The thermostat, thermistor and thermal cut-off are all parts that can be tested with an ohm meter. You will be looking for continuity of 120 volts in each. NOTE: Disconnect the power cord from the power source before removing the rear panel.

Whichever one tests open/no continuity, replace that component.

If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
January 11, 2012
See more answers

Top Parts