Model #11070842990 KENMORE Residential Dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
  • 3402844 Burner Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

To hot to touch 11070842990 Kenmore Gas dryer

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Kenmore dryer.

From the information you have provided above, A defective heating element assembly can make a dryer too hot. If the element partially shorts out, it can produce heat all the time, regardless of whether the dryer is calling for heat. Remove the heating element assembly to inspect it. The coils should not be touching each other or anything else. I would also checking the drum felt, this acts like a seal keeping the heat inside the drum. If all check out okay I would recommend setting up service just to be on the safe side. You can do this at 1800-4MY-HOME.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

Read More
Benny23 -
Sears Technician
January 08, 2015
Q:

How do you install a belt in the Kenmore drier?

A:

Installing the belt on the Kenmore dryer is an easy repair, yet time consuming as you will see in the link provide below. Hope this is helpful while an expert responds to your specific model.

Read More
Anna T -
January 20, 2013
A:

Thanks for contacting ManageMyLife.com. I understand the importance of being able to see how to change the belt on your dryer. I have a video to assist you with this. Please click here to view it. I hope this helps.

To order parts, please visit SearsPartsDirect.com with the model number.

If you do not feel comfortable repairing this problem yourself, then you can have it repaired at your home by a Sears technician. You may visit SearsHomeServices.com , follow the instructions and click on the red next button to set service.

Please feel free to let me know if you need further assistance.

Thank you for using ManageMyLife.com.

Read More
Jonathan B -
Sears Technician
January 21, 2013
See more answers
Q:

need help with part for gas dryer repair

A:

Kenmore dryers are a great invention. We don't know how much we depend on them until it does not work properly. I am attaching a few links with similar issue which may help while an expert responds to your specific question.

Read More
Anna T -
May 27, 2012
A:

The flame only comes on once but the ignitor continues to glow even though there is no flame. The ignitor should glow and click off. If the ignitor comes on but never stops glowing then the radiant sensor may be bad. It is more likely the ignitor is glowing and clicking off but there is no flame. This problem is caused by the coils or the valve. It is difficult to pin down exactly which is the problem. Most do-it-yourselfers would try the coils first and see if it helps. The coil kit is available for about $25 dollars while the valve would be close to $100 dollars. The coil kit is available from the following site: Kenmore Gas Dryer Coil Kit . I hope this helps. You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
May 29, 2012
See more answers

Top Parts