Model #11066732500 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Dryer 11066732500 Kenmore Dryer

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your dryer. Upon researching model 11066732500; I’m not showing a rear bearing that could leak. There are two roller bearings under the tub. It would be hard for those to leak grease and not hear them squeak. I recommend looking for parts that have this oil on it. Clean the oil up and run a cycle. Then inspect the parts again and trace the oil.

Thank you for choosing Sears. We appreciate your business. Have a great day.    

Read More
Jeff Wallace Jr -
Sears Technician
March 11, 2015
Q:

start switch 11066732500

A:

Thank you for choosing sears I would be happy to help you with your dryer. Upon researching model 11066732500; to test the start switch you need a muti-meter, make sure the dryer power cord is unplugged while testing or repairing. The will need to read closed for continuity when pushed, this will indicate that the switch is ok. If the switch does not read closed when pressed, then you may need to replace it. I have posted a link below of the start switch.

 

I trust this information will help you, have a great day.

Read More
CarlosZ -
Sears Technician
January 16, 2015
Q:

dryer won,t heat up 11066732500 Kenmore Dryer

A:

Thank you for choosing SearsPartsDirect.com and being a valued member.  I can certainly understand how frustrating it can be when your dryer will not heat. 

 
If the dryer is not heating you could be experiencing an issue with the thermal fuse (3392519), operating thermostat (3977767), high limit thermostat or the thermal cut-off. If you have an ohms/volt meter you can test these parts for the proper continuity. To test the parts, disconnect both wires from the components and test them at room temperature. The ohms reading for these components should be zero ohms. If the high limit thermostat is faulty, then replace the thermal cut-off as well and vice versa. They two components work together and come as a kit (279816). If they component listed above test good, then the issue may be with the heating element (279838) and I recommend testing it as well. You'll want to get a reading of 7.8 - 11.8 ohms for it to test good.





You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

 

Thank you for your question. Have a great day. 

 



therm_fuse_them_test_110.jpg (864×540)

Read More
Natasha12 -
Sears Technician
December 12, 2014

Top Parts