Model #11065922400 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


Diagnose dryer heating element and controls 11065922400 Kenmore Residential dryer


Thank you for choosing and being a valued member. I can certainly assist you in locating how to test the parts in your dryer. 

I have attached the information to assist you. 

You can also visit for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

Please resubmit your question if you have any other problems.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
October 07, 2014

Dryer Does Not Turn On 11065922400 Kenmore Residential dryer


Hello glad to help.  Thank You for choosing Sears

I am sorry and do understand your frustration when there is trouble with the dryer.

Glad to help out.   Im  looking at your Kenmore model number 110.65922400.

I see your dryer isn't starting.   You hear the click.   The first thing to check is the door switch.   I would first open the door and close it a little harder than normal and see if it will work.  You can take an ohm meter and run it to the switch and see if you have the continuity open.  If yes then you are good and if not then you need a new door switch.   This is often the case in most washers and dryers when they don't start.  That is where I would start at.   After that then you look at the switch for the power switch and the motor switch.  Try this first though.

Door switch per model 110.65922400

If you have further questions please let me know.

Thanks for choosing Sears 

Read More
Larry L -
Sears Technician
November 09, 2013

I have a kenmore dryer, model # 110.65922400. i have part # 3406107,. I cannot open the dryer top. Can you explain to me how I can open the dryer top?


I think its great that you are wanting to do some repairs on your own and I will be happy to help. I did some research and I was able to find a link that will guide you with your project. I am also adding a second link in where you can have your dryer repaired by a certified technician. I hope this helps with your dryer troubles while you wait for your expert response.

Read More
Joseph P. -
November 10, 2012

Thanks for the inquiry about raising the top of your dryer, I will be glad to assist with this.
To open the top; notice the separation of top and front cabinet (door area). About 1&1/2 inch from each end are spring clips that hole the top down. Using a puddy knife of similar flat tool, push in on each the clip (push knife between top and cabinet) while gently lifting same on other side and top will raise. always disconnect power supply before servicing appliance To replace the switch you may need to take out the screws just under the top to release the front so it will tilt out enough access the door switch.
I have added an image below that shows hoe to lift the top and get to switch, use that section of the image only as it also shows other component access.
I hope this will help, should you need additional assistance please reply with details and I will be happy to respond.

Thanks Ron H.

Read More
Ron H -
Sears Technician
November 12, 2012
See more answers

Top Parts