Model #11064732400 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Dryer quit completely 11064732400 Kenmore Residential dryer

A:

Thank you for your inquiry on your Kenmore Dryer, Model: 110.64732400. From reviewing the details on your model, I have provided a link to a couple of videos on similar model of dryers, which should be able to troubleshoot what could be causing the dryer to stop work.

Click Here

Safety Warning: Before beginning the repair, disconnect the direct power supply to the dryer to prevent the risk of injury or any electrical shock.

If you don’t feel comfortable or confident in this repair, then you can have it repaired at home by a sears technician. I have the included a link to the website: Sears Home Services or call 1-800-469-4663.

I hope this answered your question. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

Read More
Gerry 93 -
Sears Technician
April 10, 2015
Q:

if heat ellement is bad , will this cause the timmer to stop counting down 110.64732400

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your dryer and I do understand your frustration. Glad to help out. I'm looking at your model number 11064732400 and the timer itself may be bad if it stays in the same and does not advance. Here is a link for a video that will test the heating element and the timer. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
October 29, 2014
Q:

Timer continues to advance after buzzer buzzes and motor stops 11064732400 Kenmore Residential dryer

A:

Thank you for your question and I understand your concern.

Based on the model number your model does not have moisture sensor.

There is motor centrifugal switch on the motor. When the motor shuts off, contacts 2M and 1M must open and break the line 2 (L2) circuit or the line two voltage supply will travel through the heating element to timer terminal WB or timer terminal OR. One or the other timer contact will always be closed (TM and OR) or (TM and WB) which will complete the L2 path directly to one lead of the timer motor. The other lead on the timer motor has voltage all the time as long as the dryer is plugged in. So, with this said, I suspect the motor centrifugal switch 2M and 1M are stuck/welded shut causing the timer motor to never shut off. The motor centrifugal switch is not available as a separate part, the complete motor assembly would have to be replaced if you find contacts 2M and 1M stuck closed. You can confirm if contacts 2M and 1M are stuck closed with an Ohm meter. Disconnect the wires from 2M and 1M and then check for continuity across the two with an Ohm meter. If it measures continuity, contacts 2M and 1M are stuck/welded shut. NOTE: Disconnect the power cord from the power source before servicing.

I added an image below of the wiring diagram and traced the two L2 circuits to the timer motor in red. 

In order to access the motor, the top must be hinged open and then the front panel must be taken off. See images below.

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

Read More
Joey S -
Sears Technician
April 25, 2013
A:

I understand that your timer is buzzing after the motor has already stopped. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. Have a great day!

Read More
Alina -
April 25, 2013
See more answers

Top Parts