Model #11063112100 KENMORE Residential Dryer

  • Cabinet
    3 Results
  • Top And Console
    3 Results
  • Bulkhead
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

What is the part number for the belt that turns the drum? 11063112100

A:

Hello,
After looking up your dryer it shows that the listed belt for your unit is part #341241.

Read More
Brandon8726 -
Sears Technician
September 11, 2015
Q:

What to do to make the drum/barrel spin like it used to. 11063112100 Kenmore Electric dryer

A:

More than likely the Thermal Fuse has blown and needs replaced.  This can be tested by disconnecting the thermal fuse and connecting the wires together to see if the drum turns and the heating coil lights.  Remember to disconnect Brakers while doing this.  The Thermal fuse can be ordered.

Read More
Jeffrey8673 -
Sears Technician
September 11, 2015
Q:

Kenmore Dryer 11063112100 won't heat up...

A:

I am sorry that you are having some difficulties with your dryer not heating and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. Click here for the link. I hope this helps with your research while you wait for your expert response.

Read More
Joseph P. -
June 20, 2013
A:

I understand how frustrating it can become when you continue to experience an issue with your dryer. I am happy to help. Unfortunately I am unsure of which part you are referring to when you state thermal timer. The thermal cut off includes the thermostat, is this what you replaced? Was the dryer still running but not heating? When the thermal cut-off has failed it can cause the heating element to short out as well. However, I recommend checking the thermal fuse first.  The easiest way to do this is with an ohm meter. Place your meter to check ohms. Then place the leads on each terminal. The reading should be close to 0 ohms or closed. If the reading is open or OL, the thermal fuse is bad and will need to be replaced. If it's okay check the heating element.

Resistance checks are made with the dryer unplugged to avoid lethal electrical shock that is possible when internal components are exposed. I recommend unplugging the dryer and checking the heating element for resistance. Remove at least one wire from the heating element. Check the resistance across the leads of the element. Most heating elements will have between 5 and 15 ohms of resistance. If the element is open (measures infinite resistance) or short (measures near zero resistance), then it will need to be replaced.

To order parts please use our parts site, just be sure to have your model number. Here is a link to order any parts you need. Sears Parts Direct .

I hope this proves helpful but if you need further assistance please feel free to reply back to this thread. If you would rather schedule for service here is a link for the website: Sears Home Services .Thank you for using Manage My Life.

Read More
Desiree -
Sears Technician
June 21, 2013
See more answers

Top Parts