Model #11063052101 KENMORE Residential Dryer

  • Console Panel
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
  • Dryer Top
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


What would cause my dryer to turn itself on and off and works when it feels like it?


Based on your symptom the most likely failure is the control panel/touch pad or loose wire connection between the door switch and the control board. If the control board does not detect the door switch closed it will not start, if the door switch opens while running it will shut off. If it will not power up, the touch pad is likely bad, however it could be a loose wire connection on the control board.

In order to diagnose the failure will require a volt/ohm meter. The door switch circuit will need to be test as well as the touch pad operation. I added the information how to test the touch pad operation in the image below. NOTE: Disconnect the power cord from the power source before servicing. Remove each console end cap and remove the screw at the bottom of the end cap to place the console in the service position. See images below.

I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
November 27, 2009

Why won't the digital display panel light up on my Kenmore dryer?


There is not a repair manual available for this model of dryer. Most repair information is provided in the tech sheet that you may find stored in the console of the dryer. Here are the access procedures and technical troubleshooting for this problem:

First, you can try to start the diagnostic mode for the dryer as described in the second image below. Given your symptoms, it is unlikely that you will be able to enter into this diagnostic test mode. If not, continue with the troubleshooting described below.

NOTE: Be sure to unplug the dryer to completely disconnect electrical power before accessing internal components.

Since the drum light works, you have verified that proper voltage is supplied to the control board. Your failure could be in the electronic control board, the control console or the wiring harness. Unplug the dryer and remove the plastic end caps (Keys 2 and 7 in the first image below). Remove the screw (Key 13) on each side of the console that secures it to the top dryer panel. Pull the console slightly forward and then hinge it up and back into the service position (see illustration of a similar type of dryer at the bottom of the first image). This will give you access to the control board, the control console and the wiring connections.

With the dryer still unplugged, follow the steps at the bottom of the second image to test the supply connections (TEST #1). The third image provides TEST #5 for the control console. Make sure that the connector for the console is securely plugged into the control board at P3 and P4. Conduct the test on the console assembly if needed.

Using this technical information, you should be able to determine whether to replace the electronic control board or the control console. You can order either of these parts from the Sears PartsDirect website .

If you need more help with this repair, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
October 29, 2008

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show