Model #11062084101 KENMORE Residential Dryer

  • Console Panel
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
  • Dryer Top
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

wireing 11062084101 Kenmore Electric dryer

A:

Thank you for choosing SearsPartsDirect.com. I understand how important it is to have a wiring diagram for your dryer. I have included images below. If you are viewing this response on Sears PartsDirect and are unable to view the image, copy and paste the following web address to a seperate internet browser:
http://www.managemylife.com/mmh/questions/360253-wireing-11062084101-kenmore-electric-dryer
SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.
If you have further questions please let me know. Thanks for using SearsPartsDirect.com.

Read More
Lokelani -
Sears Technician
September 11, 2013
Q:

dryer error code e1

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina F. -
November 19, 2011
A:

Thank you for your question and I understand your concern.

The "E1" error code means an open "thermistor" key #42 (not thermostat key#48) or an open thermistor circuit between the thermistor and control board. The thermistor is located on the blower wheel housing. It's not the thermostat on the heating element housing. See image I added below for the location of the thermistor. An Ohm meter will be needed to test and measure the thermistor.

Open means the thermistor does measure any resistance when tested with an Ohm meter. The thermistor should not be open or shorted at any time. It should measure a certain level of resistance based on the ambient temperature it is sensing. At 70 degrees the thermistor would measure approximately 11.9 K Ohms of resistance. The thermistor is part #8577274 which can be ordered from SearsPartsDirect .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
November 21, 2011
See more answers
Q:

I have a Kenmore model 11062084101 and I am replacing the thermal cut-off and thermostat and for got to label my wires to reconnect NEED HELP

A:

Replacing parts can be a big mystery without instructions. While you are waiting on an expert to answer your question, I was searching in the Sears Parts Direct website and found your diagram picture. I have attached the link below. Hope this helps!

Read More
Dezeray S -
January 25, 2011
A:

Thanks but I looked it doesn't give me what wires go where it gives me parts....i appreciate the assistance

Read More
scott -
January 25, 2011
A:

Thank you for your question and I understand your concern. The solid RED wire will connect to one terminal on the THERMAL CUT OFF and the solid BLACK wire will connect between the other terminal on the thermal cut off and one of the terminals on the HIGH LIMIT thermostat. The RED/WHITE wire will connect between the other terminal on the HIGH LIMIT thermostat and one of the terminals on the heating element. SEE IMAGE BELOW.

NOTE: Disconnect the dryer from the power supply before servicing your dryer.

Read More
Joey S -
Sears Technician
January 26, 2011
See more answers

Top Parts