Model #11062082101 KENMORE Residential Dryer

  • Console Panel
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
  • Dryer Top
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

heating element 11062082101 Kenmore Electric dryer

A:

Thank you for choosing SearsPartsDirect.com. Thank you for your question. I know how important getting the wires connected properly can be. I have included a step by step instruction video that helps your reinstall the element. You can click here for that video.

If you do not feel comfortable making the repair yourself, I recommend a technician go out to your home.

If you would like a Sears technician to complete the repair, you can set up service at www.SearsHomeServices.com or by calling 1-800-469-4663.

I hopw this helps you. Have a great day! 

Read More
Samantha A -
Sears Technician
April 18, 2014
Q:

Kenmore electric dryer

A:

I can appreciate your need for this information.  I have included a link with an image that shows how to remove the toe panel. Remember to unplug the dryer first.  Click here to view the page.  Though this link discusses a different model number,
the mechanics are likely going to be very similar.Keep in mind that an expert will be
responding within the next two business days if not sooner and will likely offer you more information and
instruction.  I hope this will be helpful and have a nice day.

Read More
Henry -
May 27, 2013
A:

Thank you for your question and I understand your concern.

The front lower access panel is fastened at the top of panel with a couple of clips. You will need a putty knife to slip above the panel to release the clips. First, locate the two clips and then place the putty knife in front of the clips and pry up and pull out on that corner. I added an image below with the instructions to reference. 

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
May 29, 2013
See more answers
Q:

Kenmore dryer mod 11062082101

A:

I am sorry that you are having some difficulties with your dryer and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps while you wait for your expert response.

Read More
Joseph P. -
June 04, 2012
A:

The wiring diagram below has the potential causes of no heat circled. The thermal-cut-off, hi-limit thermostat and element can be checked for resistance/continuity if a meter is available. Any open circuits would indicate a bad part. You should also check the two circuit breakers providing power to the dryer. If one trips then the dryer can have 120 volts to run the motor but not have 240 volts to heat with. If you have no meter then this will be a difficult problem to pin down. I'd suggest you start by checking the thermal cut-off and hi-limit thermostat. If they are okay then the most likely cause of the no heat problem is the heater relay on the control board. There is a way to check the relay if no meter is available but extreme caution must be used. Let me know if you have a meter and if you'd like to check the relay without a meter. before making any checks remember to unplug the dryer first.

Read More
Fred M -
Sears Technician
June 05, 2012
See more answers

Top Parts