Model #11062062102 KENMORE Residential Dryer

  • Console Panel
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
  • Dryer Top
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

the dryer gets hot but does not seem consistent. lint filter is clean, exhaust is clean and clear. 11062062102 Kenmore Electric dryer

A:

Hi,
It sounds like either your heating element or one of your thermostats may be going out. If you go to our you tube site there is a video that shows you how to replace these. https://www.youtube.com/playlist?list=PLbGAdX0H4-79DY6XREor_59ijwmWjR_Kp

If you feel uncomfortable doing so I would reccommend calling a sears tech. 1-800-469-4663

Read More
Sandra8287 -
Sears Technician
September 01, 2015
Q:

i want to inpect the drum and belt. how do i open the front panel 11062062102 Kenmore Electric dryer

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you in locating the instructions to open your unit to inspect your belt. 




You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

 

SAFETY NOTICE: Be sure to disconnect power to the unit before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
August 20, 2015
A:
Natasha12 -
Sears Technician
August 20, 2015
See more answers
Q:

I have a Kenmore electric dryer model number 110.62062102 that will not tumble

A:

Thanks for contacting manage my life about your dryer model 110.62062102; sorry you are having a problem. If the dryer is not tumbling the drum the most likely cause is the belt. Your model is equipped with a broken belt switch that would normally stop the motor from running as well. You can check the belt by opening the lower access panel and see the motor, idler and belt on the right side looking into the dryer. Here is a link to order the Drive Belt should you determine it is broken and not just off the idler and motor.  If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services. Ron H.

Read More
Ron H -
Sears Technician
September 04, 2013

Top Parts