Model #11047512602 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Dispenser Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Tub And Basket Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


My Kenmore he2 plus washer model #110.47532601 : shows 5 D and than F21 code #110.47532601

A: is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using!


Read More
Joseph -
July 20, 2013

Thank you for your question. The 5d code is really SD code. The "SD" error code indicates a Suds Detection. SD is displayed when the machine/motor control analyzes drag on the basket detecting a suds-lock condition. This is generally caused by using the wrong type of detergent or just too much detergent.

The "F21" fault code will display if the drain time exceeds eight minutes. This fault code generally is caused by a restricted drain pump filter or using too much or the wrong kind of detergents.

The first thing to check and clean is the drain pump filter if the drain pump will run. If the drain pump is not running then it may have a jammed or faulty drain pump. I added an image below with instructions on how to access and remove the drain pump filter for cleaning. NOTE: Disconnect the power cord from the power source before removing the lower access panel. Also, remove all the water that you can before removing the drain pump filter or all the water will pour out on the floor. Have a shallow pan and towels handy even though you have removed all the water from the tub there will be water left below the basket.

In order to access the drain pump filter the lower access panel will need to be removed. (See images below.)

  1. Disconnect the power cord from the power source.
  2. Remove the screws (key#21) along the bottom of the lower access panel.
  3. Slide the access panel down and off.
  4. Turn the filter (key#14) counterclockwise to remove the filter assembly.

NOTE: There will be a lot of water left inside the pump so place a shallow pan under the filter before removing. I would also recommend having an old bath towel handy too.

For all your part needs go to

If you rather haveservice go to

If you have anymore questions reply to this post.

Thank you for choosing Manage My Life.

Read More
dtova00 -
Sears Technician
July 22, 2013
See more answers

How do I remove the front panels? 11047512602 Kenmore Residential washer


Error Code F-25 11047512602

Top Parts