Model #11046742700 KENMORE ELITE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Dispenser Parts
    3 Results
  • Tub And Basket Parts
    3 Results
  • Steamer, Pump And Motor Parts
    3 Results
  • Optional Parts (not Included)
    3 Results
Find part by diagram >

Question and Answers

Q:

noise during spin 11046742700 Kenmore Elite Residential washer

Q:

water will not shut off when machines goes into spin and drain cycle 11046742700 Kenmore Elite Residential washer

Q:

What is the definition of Error Code F35 11046742700

A:

Thanks for the inquiry and for using SearsPartsDirect.com. 
I am sorry to hear of the issue you are having with the Kenmore Elite washer, I know how frustrating that is to have occur.

The F35 indicates a water level pressure sensor failure. This component senses and controls water level in the washer. This failure could be caused by a pinched or broken air hose between the air trap at the bottom of the washer tub and the analog pressure sensor. It can also be caused by a clogged air trap or a failed analog pressure sensor. If you are able to unplug the washer and pull off the top panel, you can check for the probable cause of this failure. To remove the top panel, remove the screws on the very back of the panel that secure it to the washer cabinet. Pull the top panel back slightly and then and off of the washer. It is on the side wall just behind the expansion control board. You can check the air pressure hose connection and the wire harness connection on this component. If you find no problems, then you will likely need to replace the pressure switch.
Hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 
 

Read More
Jeff Wallace Sr -
Sears Technician
July 02, 2014

Top Parts