Model #11045081404 KENMORE ELITE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Dispenser Parts
    3 Results
  • Tub And Basket Parts
    3 Results
  • Pump And Motor Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Question and Answers

Q:

I have a front load Kenmore Elite washer that I am getting error codes of F 6. Is there something we can do to clear the code and fix the problem?

A:

The washer is one of the appliances that makes life so much more convenient. Error codes can be most frustrating sometimes. I found some information for you that I am hoping will help you. I am adding the links below to help you with your question while you wait for your expert response. I do hope this will help you out.

Read More
Marc H -
April 27, 2012
A:

The first priority is to remove the clothes from the washer. The 2nd image shows how to remove the lower access panel. Remember to unplug the Washer first. With the panel removed and the washer unplugged you can reach up with your hand and grab the small round tab on the bottom of the door switch. See the 3rd image for help with this. Pull the tab down to manually unlock the door. The F06 error code means the control is not seeing the motor run. Once you open the door close it and try another cycle. Try to check if the motor is running when the F06 code is displayed.

Read More
Fred M -
Sears Technician
April 28, 2012
A:

While examining the MCU connections, I noticed that three of the four shock absorbers that connect from the drum to the bottom were leaking, albeit slightly. There were a few drops of hydraulic oil on the shafts of three of the shock abosorbers. I have ordered new replacements at approx $35 each for all four shocks. My error code F06 occurred with two minutes of spin time left. Hit pause/cancel and opened the door and removed the clothing from which the water had been pretty well extracted. The machine was not jumping or bouncing but it was vibrating-- especially noticable in items setting on top of the washer. Since it had done OK before the error code appeared, I've decided to go with the new shocks. My machine was purchased in 2007. This will be my first part replacement of shocks or any major parts. I sure wish I could find a way to check out the MCU for the HE4T Elite. There must be a diagnosis instruction somewhere for the MCU. Sears should publish one.

Read More
Ronald -
December 01, 2015
See more answers
Q:

outer glass on front door 11045081404 Kenmore Elite Residential washer

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your washer. Upon researching model 11045081404; the complete door for this model is not available as a complete door. We cannot guarantee that the door will create a proper seal without the outer glass.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
July 23, 2015
Q:

capacity 11045081404 Kenmore Elite Residential washer

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you in locating the capacity of your washer. 

I did look into the model number you have provided, and I have found that this unit is 3.8 cubic feet. 

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day. 

Read More
Natasha12 -
Sears Technician
October 14, 2014

Top Parts