Model #11044832200 KENMORE ELITE Residential Washers

  • Top And Cabinets
    3 Results
  • Door And Latch
    3 Results
  • Control Panel
    3 Results
  • Dispenser
    3 Results
  • Tub And Basket
    3 Results
  • Pump And Motor
    3 Results
  • Pedestal
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore Elite HE3 110.44832-200 cu ft?

A:

The washer has a 3.7 cubic foot capacity. Please reply below if you need further assistance on the washer.

Thank you for using Manage my life.

Read More
Fred M -
Sears Technician
November 12, 2013
A:

I paused my machine in less than 1 minute after it started to add clothing, it will not start again. Is there a reset button?

Read More
Sherry -
June 08, 2015
See more answers
Q:

I ran the Machine diagnotic program and it failed on C:01 and C:06. 11044832200 Kenmore Elite Automatic washer horizontal axis

A:

Thank you for choosing SearsPartsDirect.com and being a valued member.  I can certainly understand how frustrating it can be when your washer is not working properly.
 
 
Motor Continuity Test

Disconnect the wire harness
from the motor and measure the
resistance of the motor. Use the
following table:
Pins Results
1 to 2
2 to 3
1 to 3 
Normal = approx. 6 ?
Abnormal = Infinity

C:01
Fill by cold water inlet valve.
What needs to be checked:
? Flowmeter
? Cold water inlet valve 

C:06 Drain pump is ON.
? Drain pump


Water Temperature Sensor
Disconnect the wire harness from
the water temperature sensor and
measure the resistance of the
sensor. Use the following table.
An abnormal condition is an open
circuit.
Temp. Results
32°F / 0°C 35.9K ?
86°F / 30°C 9.K ?
104°F / 40°C 6.6K ?
122°F / 50°C 4.6K ?
140°F / 60°C 3.2K ?
158°F / 71°C 2.3K ?
203°F / 96°C 1K ?

I recommend checking the water temperature sensor and the motor. 
If those check out good then I recommend a service technician. It may be the electronic control itself. 

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
May 28, 2015
Q:

How do I replace the large rubber gasket on the front of the tub of this front-loader washing machine? 110.44832.200

A:

Thank you for choosing SearsPartsDirect.com and being a valued member.  I can certainly understand how frustrating it can when your washer door is building up with mold. The washer gasket usually needs to be wiped down after every use of the washer and the door should be left open just a little bit to let the gasket air out. This will usually prevent the buildup of the mold on the gasket.

 I have attached the instructions to change the gasket on your washer. 

Replace Bellow[1]



You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
May 19, 2015
A:

Thanks for your reply. Unfortunately no instructions for replacing the gasket were attached to your email. I visited the partsdirect site and was unable to find the parts number for the gasket or repair information. Can you please provide this information. Thanks for your help.

Read More
Susan -
May 19, 2015
See more answers

Top Parts