Model #11029682801 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

kenmore washer 11029682801: not enough hot water!

A:

If your a do it yourself kind of person. I found this really similar question on this link I found on why you might not be getting hot water on your Washer. I attached the link below for you to check out while you are waiting on an expert to answer your question. Hope this helps! Good luck.

Read More
Dezeray S -
October 04, 2010
A:

Your specific model washer has an automatic temperature control (ATC) which will regulate the cold, warm and hot washes. The hot water will be regulated to a target temperature of 105 degrees. This will be the approximate temperature of the water in the tub after the fill has completed. See image below for the warm and cold water wash fill temperatures. All rinses will be tap cold water. The water temperatures are regulated by the Department of Energy and can not be changed.

Read More
Joey S -
Sears Technician
October 05, 2010
See more answers

Top Parts