Model #11028824790 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Control Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Gearcase, Motor And Pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Miscellaneous
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do I Fix leaking washer? 11028824790 Kenmore Automatic washer

A:

Thank you for choosing SearsPartsDirect. I can certainly understand how frustrating it can be when your Washer is leaking. In order to get you instructions to fix the leak on your washer we will need to know where the leak is coming from or around what area the leak is coming from on the unit. I will need more information on what cycle it leaks on? If it leaks when unit is not in use? Etc. Once I have more information on the issue I will be able to get you instructions to repair your washer. 

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

Thank you for your question. Have a great day. 

Read More
Natasha12 -
Sears Technician
May 29, 2014
Q:

How do I find out the capacity of my older Kenmore washer model 110.28824790?

A:

This model of washer has 3.2 cu. ft. of capacity.

Read More
Lyle W -
Sears Technician
Q:

How do I access the lid switch on my washer in order to replace it?

A:

I added three (3) images in order to reference the parts and key numbers.

To access the lid switch (key#11) the washer cabinet will need to be removed.

  • First, disconnect the power cord from the power source.

  • The console (key#26) will need to be placed in the service position by removing two (2) screws, one (1) screw located at the bottom of the left hand end cap (key#7) and one (1) screw located at the bottom of the right hand end cap (key#10).

  • In order to access the two (2) screws hidden under the left hand end cap trim (key#8) and under the right hand end cap trim (key#11)the two (2) end cap trim pieces will need to be removed.

  • To remove the trim, place you finger behind the trim at the very top and bend it up enough to clear the console and then hinge it towards the front and off.

  • Remove the hidden screw under each end cap trim. Slide the console forwards about 1/4 inch and the raise it upwards and hinge it over the rear panel.

  • Disconnect the 3 wire lid switch harness plug located on the top. Pop the two (2) cabinet clips (key#6) off.

  • Place the tip of a flat tipped screw driver down into the first valley and then push the handle end to the rear of the washer to pop off the cabinet clips.

  • Open the lid and grab the opening and tilt the top of the washer cabinet forwards just a few degrees and then walk it backwards and off.

  • The lid switch mounted under the main top is now accessible to remove and replace.

Reverse the procedure to re-assemble the washer.

Read More
Joey S -
Sears Technician

Top Parts