Model #11027222600 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Machine Not Operating 11027222600 Kenmore Residential washers

A:

Thank you for your question and I understand your concern.

There is not a "reset button" on the washer. If you're certain the wall outlet has the proper voltage supply, it likely has a faulty lid switch. 

If the washer will fill with water or it is already filled with water, the washer will not operate if the lid is open or if the lid switch is faulty. The lid must be down and it must have a working lid switch or the washer motor will not come on in order to agitate, drain or spin. It will however fill or add water without the lid being shut.

The lid switch is activated by the left lid hinge. When the lid is lowered, the end of the hinge must strike the lid switch in order to close the switch and complete the neutral circuit/path to the motor. 

The lid switch is located under the control panel on the left side. In order to access the lid switch, the control panel must be placed in the service position. There is a spring clip located under the front of each control panel end cap. You will need to slip a thin putty knife under the front corner of the control panel end cap and push the spring back and while holding pressure, lift that corner of the control panel up. Repeat the steps for the other side. I added an image below showing where to slip the putty knife under. The control panel in the image below is different than yours but the procedure is the same way. Once you have both clips released, slide the control panel towards the front of the washer a little and then lift it up and hinge it over the rear panel. NOTE: Disconnect the power cord from the power source before servicing.

Once the control panel has been hinged over, you will see the lid switch assembly on the left side. If the hinge arm is bent a little, it will not strike and close the lid switch. I added a couple of images below to reference.

This may be the issue. If not, please reply and I will be glad to assist you further.


 

Read More
Joey S -
Sears Technician
October 31, 2013
Q:

model # 11027222600 washer filled then stopped timer advanced but no other cycles completed. the machine makes a loud humming noise

A:

The Managemylife web site is a good resource of information to find out what may be happening and what options are available to you. I'm sorry to hear about the difficulties with your Kenmore washer. I did some research at Managemylife website and found this expert answer to a similar question that may help until your expert can respond. I have attached the link below so you can check it out. I also found a video to help you that is attached in the link below.

Read More
James -
May 09, 2012
A:

I know that it can be very frustrating to have issues with your washer. This sounds like the motor drive coupler or the motor itself has failed. Tilt the front of the washer up a couple of inches & look on the floor under the middle section, if you see rubber shavings or broken plastic pieces, this is a sign that the motor drive coupler has failed. Please click on the image provided for the replacement instructions on the motor coupler. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
May 09, 2012
See more answers
Q:

Older Kenmore model capacity needed

A:

I know how important it is for you to have the capacity for your appliances. I researched your question and was able to find the capacity of your washer. I attached the link below. An expert will respond shortly with further information. I hope this helps.

Read More
Jackie S -
February 17, 2012
A:

I did see that link. I am hoping an expert will resond with the info in kilos =) Thanks for your help!

Read More
Jen -
February 17, 2012
A:

  • Washer is 2.5 cu. ft
  • Dryer is 6.5 cu. ft.

I hope this helps.

Read More
Korinna S -
Sears Technician
February 17, 2012
See more answers

Top Parts