Model #11026942503 KENMORE ELITE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Question and Answers

Q:

Lid switch

A:

I'm sorry to hear that you are having some difficulties with your Kenmore Washer. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
James -
November 01, 2011
A:

Thank you for the question.

I am sorry you are having a problem with the washer. I will be able to help you with this repair. First, unplug the washer from the wall. Then click on the image below. The image has the instructions for replacing the lid switch. Use a putty knife to release the console and flip it back. Then remove the wires from the switch and take out the ground screw. Now lift the lid and remove the switch. The lid has to be opened to take the switch out. While holding the lid up, install the new switch in the reverse order.

I hope this is helpful. If you need further assistance, please reply below with more details.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
November 02, 2011
A:

My Kenmore 110 26942503 stopped working and the information on the web suggested that the lid switch was not working. I ordered a new lid switch and installed it. There is water in the tub, so I put the cycle to spin and I heard the electrical start on the washing machine and then the circuit breaker serving the washing machine would break. Does anyone have any suggestions of what to do next to repair the machine?

Read More
Bob -
May 05, 2015
See more answers
Q:

How to change water pump on model 110.26942503 washer 11026942503 Kenmore Elite Residential washers

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your washer and I do understand your frustration. Glad to help out. I'm looking at your model number 11026942503 and the replacement is fairly easy. Here is a link for a video that will help with the repair. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
October 27, 2014
Q:

I need an inlet hose for a Kenmore Elite washer please. 110 26942503

A:

Thanks for the inquiry and for using SearspartsDirect.com.
The cold and hot water inlet hoses are now the same between the two and the part number has changed from the originals. The part number now is 89503 and is not side specific as the originals were, so you can order two of 89503 for both sides. The originals had a red coupler for the hot and a blue coupler for the cold, however, the coupler on the new ones is just brass in color.
For convenience, I have included a blue link below that you may click on to be directed to the PartsDirect page to view and purchase the hoses. It is recommended to replace them both at the same time.

Inlet Hose for Model 110.26942503

Let us know if we can be of any further assistance and thanks for using SearsPartsDirect.com. 

Read More
Jeff Wallace Sr -
Sears Technician
February 22, 2014

Top Parts