Model #11026752500 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts, Miscellaneous Parts, Optional Part
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Heavier loads are still wet after spin cycle is done 11026752500 Kenmore Washer

Q:

Spin cycle does not always work 11026752500 Kenmore Washer

A:

Thank you for choosing SearsPartsDirect.com and being a valued member.  I can certainly understand how frustrating it can be when your washer is not working properly.

 When the motor coupling goes bad it will cause your unit to not spin or agitate. It may be barely going out and causing intermittment spinning. 

285753A is the motor coupling. 


63907  also the suspension spring is what keeps the washer balanced. If those are worn then your washer will not be balanced in spin cycle. 
 

You will need to take your agitator apart to check to see if the agitator clutch dogs are broken. When they break your unit will not agitate correctly and it will make a grinding/clicking noise. 

Here is the part number for just the dogs. 80040 

Example 2-piece agitator assembly

First step is to remove 2 screws from the console front. There should be one on each side and they will be under the plastic end cap covers that will pop off. Then the console will flip back on hinges.
 
Then you will see two large clips that you will need to pop out with a screwdriver. They attach the cabinet to the rear panel. You will also need to unplug the lid switch wires that are in the cabinet top. Then the whole cabinet should come off revealing the rest of the washer.
 
 The pump unclips but don't remove the hoses or you will get water. Then there should be two screws that hold the motor retainers in place remove those and unplug the motor. Pop off the motor retainers and the motor should come off revealing the motor coupler. part #285753A.

110_top_wash_disassem.gif (1621×1749)

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others. 

 

 

Read More
Natasha12 -
Sears Technician
August 03, 2015
Q:

smell of burnt rubber 11026752500 Kenmore Washer

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your washer. Upon researching model11026752500; there is a rubber motor coupling in between the motor and gear case. This coupling is the usually suspect when you smell burning rubber. It is key number 13 in the diagram. Click here for the diagram.

Thank you for choosing Sears. We appreciate your business. Have a great day.    

Read More
Jeff Wallace Jr -
Sears Technician
February 04, 2015

Top Parts