Model #11026682503 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Control Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator/basket/tub
    3 Results
  • Brake/clutch/gearcase/motor/pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Brake And Drive Tube
    3 Results
  • Gearcase
    3 Results
  • Water System
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Sears 80 Series washer, model # 11026682503 Spin cycle works but doesn't sound right or seem to have enough power...what might be the problem?

A:

I'm sorry about the difficulties that you are experiencing with your Sears 80 Series washer. I did some research at Managemylife.com and found an expert answer to a similar question that may assist you until your expert can respond to your specific question. I have attached the link below. If you decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links will help until your expert can respond.

Read More
James -
April 12, 2011
A:

There is no belt on this model. There is a motor coupler but if the washer agitates okay then coupler is okay.

From the description you give I suspect the problem is with the basket drive and/or clutch. You might see the washer spin with a light load but not spin with a heavy load.

The basket drive and clutch can be changed by removing the transmission. On a scale of 1 (easy) to 10 (difficult) this would be about an 8.

The spin bearing might start out as a small squeal/squeak. The noise eventually will sound like a freight train going through the house.

One thing to consider is that brand new similar washers cost about $329 dollars.

I hope this gives you an idea of what you have to deal with. You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
April 13, 2011
See more answers

Top Parts