Model #11026652502 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts
    3 Results
  • Miscellaneous Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Spin cycle sometimes works on washer.. 11026652502 Kenmore Washer

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Kenmore washer.

From the information you have provided above, I can understand the frustration of having your washer malfunction, after researching model number 110.26652502. it seems to me like there is a good chance the coupler is causing this issue. I would suggest checking it out and replacing it to see if this solves your problem. The coupler may be stripped and not working properly that’s why the clothes sometimes come out wet. The part number for the coupler is 285753.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

Read More
Benny23 -
Sears Technician
April 01, 2015
Q:

Why does my washer pump leak after idled for 4 months?

A:

Your problem sounds like your leaving the washer for the winter.

There is always some water left in the washer. If you leave your washer in an area that might be exposed to freezing temperature then the pump can be damaged by the freezing water that is left in it. As the water freezes it expands and damages the pump seals.

There is a process called winterizing the washer that will help with this problem.

The image below gives you the instructions for this.

Read More
Fred M -
Sears Technician
February 23, 2009
Q:

How do I fix my Kenmore washing machine that stops once it fills with water?

A:

The wiring diagram for your washer is shown in the image below. When the washer is full, the water level pressure switch should be opening the contact from V (Violet wire) to P (Pink) and it should be closing the contact from V to T (Tan). Since the washer stops filling, it appears to be properly opening the V to P contact to stop the fill. It does not appear to be closing the contact from V to T to begin the agitation cycle.

The second image below shows the procedure for accessing the pressure switch on a similar model of washer. Unplug the washer and hinge the console back to the service position as shown. Check the wiring connections on the pressure switch. If you have a volt/ohm meter, you can unplug the wires on the pressure switch and check the continuity between the contacts for the Violet and Tan wires with the washer full of water. If you do not measure near zero ohms of resistance between the contacts where these wires connect to the pressure switch, then the pressure switch is bad and will need to be replaced.

If you do measure near zero ohms of resistance between the Violet and Tan contact on the pressure switch with the washer full, then it is likely that you have a broken wire or timer contact failure in the washer.

This information should help you fix your washer problem. If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
October 28, 2008

Top Parts