Model #11025292500 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts, Miscellaneous Parts, Optional Part
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Cubic Feet for Washer Model: 110.25292500

A:

I can understand your concern over wanting to obtain this information for your washer. While you are waiting for your expert answer, I did some research on the unit. At this time, I was unable to locate information that would be helpful in regards to your question. Some of these questions that are asked will need specific research and will be answered by an expert with-in two business days but usually sooner.

Read More
Julio -
November 19, 2012
A:

Thanks for contacting ManageMyLife.com. Washer 11025292500 shows to be 2.5 cubic feet.

Please feel free to let me know if you need further assistance.

Thank you for using ManageMyLife.com.

Read More
Jonathan B -
Sears Technician
November 20, 2012
See more answers
Q:

why does my kenmore washer model 100.25292500 stop after it completely fills up and then completely stop even when the lid is down?

A:

Hand emptying the washer is not something you want to contemplate repeating. The expert can help with the diagnosis and directions but I think the model number is incorrect. Check the first three digits again and resubmit on this same thread if different. If you decide dealing with repairs yourself is not something you are comfortable doing, an option is to visit Sears Home Services and use the scheduler. I attached the link below.

Read More
Barbara H. -
March 20, 2011
A:

Correct model number is 110.25292500. I'd like to check to see if the problem is a loose lid switch before I go through with an appointment. We've also had recent issues with the washer making a lot of noise due to it being off balance so maybe that has contributed to our most recent problem. The washer started to work again last night, but I'm sure we aren't far from it stopping again.

Read More
kelbrig -
March 21, 2011
A:

Thank you for your question and I understand you concern.

Based on your symptom it sounds like the lid switch is not always closing and completing the circuit in order allow the motor to operate. You may need to bend the hinge just a little so that the lid switch will close every time the lid is shut.

In order to access the lid switch will require placing the control panel in the service position. I added an image below showing how to release the two clips. Note: The picture of the control panel will look different but the procedure is the same.

NOTE: Disconnect the power cord from the power source before placing the console in the service position.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
March 22, 2011
See more answers

Top Parts