Model #11024996300 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts
    3 Results
  • Miscellaneous Parts Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

washer overfills

A:

It's great that you're determined to fix this problem with the washer yourself. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question.

Read More
Yadira B -
March 27, 2013
A:

Hi,

Thanks for contacting ManageMyLife. I understand how frustrating it is having trouble with your appliance not working.

In the console is the relay board for the fill valve.   The pink to white should be checked this is the relay to the fill valve and when not filling with water it should read 120 volts AC.  The cold valve should also be checked for voltage when not filling on the yellow wire with the red tracer to white. 

Then the cabinet would need to be removed and by the way you do not need to remove the console.  The whole console will flip up and over the back panel.  You can remove the cabinet and do all the check with the console on and the unit working.  I will send instructions.

NOTE:

  Always unplug or de-energize electrical equipment before removing covers or attempting service.

Be careful and wear appropriate hand protection when working around sharp metal parts.

NOTE:  Live voltage checks are dangerous, and possibly deadly. Exercise caution at all times.

If you are not comfortable working with live electricity I recommend you call a Sears Home Services technician.

 

Please feel free to let me know if you need further assistance. We are always here to help.

Thank you for using ManageMyLife.com.

Bill

Read More
Bill__W -
Sears Technician
March 27, 2013
A:

Thanks much for the instructions on removing the cabinet. But I"m still without a service manual. When I click "manual" all that comes up is a one page paster that describes the controls. I"d like to have a service manualat my disposal when make the next attempt to fix my washer. I mean the manual that describes what should be on and what should be off for each stage of the washing cycle. this will make my next attempt more conclusive. I'm a geriatric, so am computer intolerant, but appreciate the information I can discover.

Read More
august -
April 02, 2013
A:

August, No service manual is available on line for you for free to download. The what is on and what is off is something called a esterline chart and it is very hard to read and your problem is the washer is overfilling. The pressure switch works line this. In fill the pressure switch routes power to the water valves until the set level is reached, The pressure switch then opens stopping the voltage from going to the valve. Now if the valve continues to put water into the washer a. disconnect the power plug to the valve and if water still comes into the washer b. check the valve filter screens and clean if needed. It water is still entering the washer and you have to turn off the water at the faucet c. check the water pressure. The valve requires 20-120 pounds a square inch. to hold the valve closed. If the pressure is good. Simply replace the valve. There is no chart for the checks you should do for the problem. There is a manual call a repair manual and it is available by following this link below . The D.I.Y. manual cost around 20.00. Good Luck with the checks.

Read More
Bill__W -
Sears Technician
April 02, 2013
A:

Bill, Yadira, YOu guys have given me a lot to check for on my next foray into and behind my washer. Most interesting is the pressure requirements for the valves to operate. I think I'll check the water pressure and back flush the hoses, too. I don't know if there has been work on the water distribution system around here, which could introduce a lot of stuff in the water lines. I'll get on this next week, and I"ll let you know how it went. Jaxel Sends.

Read More
august -
April 04, 2013
See more answers
Q:

washer overfills

A:

An overfilling washer wouild be a concern. The expert will review this model to respond. I did locate a similar question that may provide some help. I also added the Sears Home Services link if a technician is needed.

Read More
Barbara -
March 24, 2013
A:

Thank you for your question.  I am sorry you are having a problem with your Kenmore 110.24996300 washer

There are two likley causes for this problem.  The water level switch may be defective or the clear plastic hose that connects the air dome to the water level switch may have a pin hole or be kinked so no air pressuer is reaching the water level switch to trip it from fill to agitate. 

Since the valve will shut off I suspect they are okay.

My first suggestion is to raise the console to access the water level switch.  With the drum empty, remove the hose and blow through it towards the air dome.  You should be able to blow through the hose.  You might even hear bubbles as you blow through the tube.  Try this first and reply below with any additional details for further assistance. 

The image below will show how to raise the console. 

Caution:  Before attempting any repair, unplug the washer from the wall. 

You can also have the problem checked and repaired in your home by a Sears technician.  Here is the link: Sears Home Services Washer Repair. 

 You can reply below with any additional details or questions for further assistance. 

 Thank you for using Mange My Life. 

Read More
Fred M -
Sears Technician
March 26, 2013
See more answers
Q:

How do I remove the console on my Kenmore washer?

A:

With the washer unplugged, follow the steps in the first image below to release the console and hinge it up and back into the service position. The second image shows how to pull off the cabinet. Your console will look slightly different than the one shown below, but the method for releasing the console is the same.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician

Top Parts