Model #11024652300 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Control Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Brake/clutch/gearcase/motor/pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Miscellaneous
    3 Results
  • Brake And Drive Tube 388952
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Washing machine won't restart after opening and closing lid

A:

Further to the original post above: I just noticed my repair parts list is for a different model of machine: 110.12502100. Are the part numbers in this part list valid for my model which is 110.24652300? Are there any instructions for how to disassemble the laundry machine to access the lid switch?

Read More
Dan -
September 28, 2013
A:

Further to the above posts: After emptying the wash basin/tub, I discovered the basin will refill automatically. However, once filled the cycle stops and does not continue. It will not agitate or drain. So does not appear to be a lid switch issue after all.

Read More
Dan -
September 28, 2013
A:

Doing some searching on the site, looks like might be the lid switch after all. Will try to access the switch based on some instructions for other machines.

Read More
Dan -
September 28, 2013
A:

Problem solved. The lid switch unit had separated. Possibly the glue holding switch together dried out and failed. I placed a small C-clamp on the switch to hold it together, and now it works fine. For future reference, the lid switch model number printed on the unit is 3949238. Other numbers printed on the switch include 10800-B1 and 0323D.

Read More
Dan -
September 28, 2013
A:

Thank you for submitting your question. I understand your concern and I will be happy to assist you. If you're like to test the lid switch to verify the part, the switch can be checked two ways. The first way is with a volt/ohm meter and you can check continuity across the two terminals on the switch. The circuit should show open and closed as the lid is open and closed. If you have no meter then the lid switch can be bypassed to see if it is the problem. The idea is to remove both of the wires from the lid switch and join (jump) them together with a small wire. With the lid switch bypassed you can see if the washer will drain and spin. The image below shows how to remove the cabinet to access the lid switch but look at the bottom of the instructions to see how to bypass the lid switch. Remember to unplug the washer before performing any test or repair. You can order parts from our Sears Parts Direct web site. I hope this helps. Please reply back to this thread if you require further assistance. Thank you for using Manage My Life.

Read More
Tykara -
Sears Technician
September 30, 2013
See more answers
Q:

Dryer and Washer manufacturing date

A:

I can understand your need for the manufacturing date for both your washer and dryer. While you are waiting for your expert answer, I did some research on the unit. At this time, I was unable to locate information that would be helpful in regards to your question. Some of these questions that are asked will need specific research and will be answered by an expert with-in two business days but usually sooner.

Read More
Julio -
March 18, 2013
A:

Thank you for contacting ManageMyLife.com regarding the age of the washer and dryer you are looking to purchased. In order to determine the exact date, the serial numbers for each appliance will also be needed. According to the parts list for the washer, this model was manufactured in 2003.

The 110.C646452300 number you provided, is not being recognized in the system as a valid model number. If this unit is a Canadian model, you will need to contact Sears Canada for this information. If you may please respond to this thread with the serial number of the appliances and the model number for the dryer, I will gladly research the age of the units.

Thank you for using ManageMyLife.com.

 

Read More
Korinna S -
Sears Technician
March 19, 2013
See more answers

Top Parts