Model #11024054300 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts
    3 Results
  • Miscellaneous And Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

kenmore elite washer model 110.24054300 water level not working properly

A:

Thank you for your question. First check your drain hose make sure it is not in too far. Here is a video to help. Or, your symptoms may indicate a failure of the water level pressure switch (see images). A contact in this pressure switch is not closing when the washer is full. You could have a bad switch or a problem with the air pressure hose attached to it. Unplug the washer and check the hose for kinks or leaks. If the hose is okay, replacing the pressure switch should fix this problem.

For further assistance, please respond to this thread.

To order parts go to www.SearsPartsDirect.com

Thank you for choosing Manage My Life.

Read More
dtova00 -
Sears Technician
August 30, 2013
Q:

Replace timer on kenmore washer 110.24054300

A:

Manage My Life is a great website to speak directly to an expert who can help you every step of the way to solving the problem you are having. An expert shall have an answer to your question within 24 to 48 hours. Have a great day.

Read More
Alina F. -
September 03, 2011
A:

Thank you for your question and I understand your concern.

The control panel is secured down to the top with two spring clips located under the front of each control panel end cap. You can use a putty knife to slip under the front of the end caps and then push inwards and pry the corner up. I added a YouTube video showing how to release the control on various models. Click here to view video.

Read More
Joey S -
Sears Technician
September 05, 2011
A:

Thank you for your question and I understand your concern. The control panel is secured down to the top with two spring clips located under the front of each control panel end cap. You can use a putty knife to slip under the front of the end caps and then push inwards and pry the corner up. I added a YouTube video showing how to release the control on various models. Here is the link |http://www.youtube.com/watch?v=9K1KHEogf3c] to view video.

Read More
Joey S -
Sears Technician
September 05, 2011
See more answers
Q:

How do you access the control panel to test control?

A:

There is a spring clip under each end cap that must be pressed inwards to release the control panel from the top.

I added an image below with instructions on how to place the console in the service position. You did not state what the problem is. If the washer will not operate at all, check the lid switch. The lid switch makes and breaks the line voltage before it reaches the timer.

Read More
Joey S -
Sears Technician
July 15, 2009
A:

Joey, thanks. I am trying to check continuity on the lid switch, but I am unable to disconnect the wiring harness from the upper control panel to put my meter on the leads. What is the secret?

Read More
Pam -
October 21, 2011
See more answers

Top Parts