Model #11022064101 KENMORE ELITE Residential Washers

  • Top And Lid
    3 Results
  • Cabinet And Frame
    3 Results
  • Washplate, Basket And Tub
    3 Results
  • Control Panel
    3 Results
  • Brake, Motor And Pump
    3 Results
  • Suspension
    3 Results
  • Miscellaneous
    3 Results
  • Brake And Drive Tube
    3 Results
Find part by diagram >

Question and Answers

Q:

What parts come with the U-joint kit?

A:

Yes, the u-joint kit will come with:

  • 8533210 Inner Wash plate
  • 8532052 U-Joint
  • 8520855 Lock Nut
  • 8312689 O-Ring Seal
  • 8282519 Bolt (6)
  • Installation instructions
The bearing will come installed in the inner wash plate and the 8312686 are small o-ring seals that will also come already over the six (6) openings that the six bolts thread into.

The new components are not compatible with any of the old components. Do NOT use any of the old parts with the new kit parts in any combination!

I added the installation instructions in the images below.

Read More
Joey S -
Sears Technician
A:

I have found a broken spring on one side of the leveler. How do I remove and repair it?

Read More
Dennis -
June 11, 2012
A:

Where can I procure the spanner wrench for the lock nut?

Read More
Brian -
August 10, 2012
See more answers
Q:

I have a kenmore washer 110.22064101 & its not draining. It does fill, agaite & spain but doesn't drain. Is it going to be the vaule or a pump motor.

A:

A washer is definitely something we depend on and when it begins to malfunction it can be a huge inconvenience. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question.

Read More
aashe -
December 04, 2011
A:

Thank you for your question and I understand your concern.

It could have a faulty drain pump or drain pump motor, a faulty control board or it may have an object stuck in the sump canister. The sump canister has two check balls inside. If one of the two check balls can not seat properly; it will not drain. See images below. The sump canister with the two check balls is not removable. Use a bright flash light to illuminate the canister and check to see if there is something in it preventing the check balls from seating. If you find something in the sump canister; remove the hoses and try to fish it out with a wire or some other tool that will reach in grasp the item.

I added an image below with some useful diagnostic information if you feel confident in repairing it yourself.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
December 06, 2011
See more answers
Q:

What is the capacity of my Kenmore Elite Calypso Washer model 110.22064101?

A:

Hello, Finding the correct information for your appliance is important. I attached a link that should provide more complete information. Hope this helps!

Read More
Barbara H. -
July 02, 2010
A:

I do not need a part, but I do need to know the cubic foot capacity of the washer to compare to another model.

Read More
RickfromWichita -
July 03, 2010
A:

Your model is listed as 3.5 cubic ft.

Read More
Tammy S -
Sears Technician
July 06, 2010
See more answers

Top Parts