Model #11020932993 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Control Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator,basket And Tub
    3 Results
  • Brake/clutch/gearcase/motor/pump
    3 Results
  • Machine Base
    3 Results
  • Wire Harness
    3 Results
  • Water System
    3 Results
  • Miscellaneous
    3 Results
  • Brake And Drive Tube 388952
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

What would cause my Kenmore washer agitator to begin moving while the washer is filling?

A:

I assume when you say that the agitator starts moving that the motor starts running while it’s filling with water. If this is your symptom, it's a very uncommon failure. In order for the washer to begin agitating before the water reaches the set level it would have to have a pressure switch failure and/or a timer failure.

With this type of symptom, I recommend calling a service technician to properly diagnose and repair your washer. You could call Sears at 1-800-469-4663 in order to set up a service appointment and have your washer repaired.

Read More
Joey S -
Sears Technician
March 19, 2010
Q:

Where can I get a water pump for my Kenmore washer?

A:

The part number (3352293) of the water pump that you submitted is not a valid part number. The correct drain pump part number needed is part# 3363394 and should be readily available at any Sears’s service center or at any Appliance Parts supply. It also can be ordered directly from Sears Parts Direct.

If you are referring to the water inlet valve, the part# is 285805. Both parts can also be ordered from Sears Parts Direct.

I added the link to Sears Parts Direct below.

Read More
Joey S -
Sears Technician

Top Parts