Model #11020132001 KENMORE Commercial Washers

  • Top And Cabinet Parts
    3 Results
  • Console Panel Parts
    3 Results
  • Meter Case Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts, Miscellaneous Parts, Optional Part
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore heavy duty commercial washers model 110.27272600 and 110.20132001

A:

I'm sorry about the difficulties that you are experiencing with your commercial washers. I did some research at managemylife.com and found an owners manual that goes over some trouble shooting that I hope will assist you until your expert can respond. I have attached the link below. If you would like assistance from a qualified technician I have also attached a link to searshomeservices.com. I hope these links will help until your expert can respond.

Read More
James -
January 25, 2011
A:

Thank you for your question.

I have looked up both model numbers you have submitted. Let's start with the older of the two. If this washer is not filling to the proper level in the rinse cycle, I recommend checking the pressure switch hose. To do this drain all of the water out of the washer and unplug it. Then access the pressure switch and remove the pressure hose. It is the small clear hose. Blow into the hose. It should be clear. If the hose is clear, I suspect the pressure switch is defective. Before replacing the switch, I recommend confirming there is a problem, because you have two different washers. Now lets move to the newer washer. This washer has two pressure switches, one for wash, and one for rinse. This washer will fill full on the wash cycle and the rinse is roughly 5 to 7 inches below that. This is normal. The washer was designed this way to meet water usage regulations. I hope this is helpful.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
January 26, 2011
See more answers

Top Parts