Model #11020056991 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Brake/clutch/gearcase/motor/pump
    3 Results
  • Machine Base
    3 Results
  • Control Panel
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Miscellaneous
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

PF light keeps flashing and won't stop when clear is pressed 11020056991 Kenmore Washer

Q:

Why won't my Kenmore washer drain?

A:

I reviewed the information provided in your previous question: What is wrong with a Kenmore model 110.20056991 Catalyst washer when it will not drain and flashes an LD code?

The images and diagrams appeared to be okay when I viewed them on my computer. There may have been a problem with the website that has now been cleared up. If you are having trouble viewing them, I recommend that you call our Manage My Life Member Services Team at 1-800-803-6775 6 a.m. – 11 p.m.(CT) 7 days a week. They may be able to help you view the images properly.

The diagnosis and repair procedures provided in the previous answer should help you resolve this draining problem in your washer. If the washer is recirculating instead of draining then you will likely need to replace the 2 way valve. A control board problem or wiring failure could also cause this problem. If the water is not recirculating then you could have a clog in the drain system or a failed pump. You may be able to use the images provided in the above answer to access and check the drains system (with the washer unplugged). This washer is more complicated than most washers. If you are not confident that you can properly diagnose and repair the washer using the procedures and diagrams provided in the first answer, then I recommend that you call a Sears Service technician to repair the washer. Here is a link for the Sears Service website: Sears Home Services .

Read More
Lyle W -
Sears Technician
February 12, 2010
A:

Same problem-different model. It was the underwire of a bra stuck in the drain hole. Whole thing had to come apart. Good luck.

Read More
syerkess -
February 11, 2010
See more answers
Q:

What is wrong with a Kenmore model 110.20056991 Catalyst washer when it will not drain and flashes an LD code?

A:

The LD message indicates a "long drain" and from the description you give the washer did not drain.

You don't mention what is happening when the washer should be draining out. The pump could be jammed or blocked with clothing.

The washer should recirculate the water over the clothes. If the motor pump is running then the problem might be with the 2 way valve. If the water is recirculating over the clothes instead of draining then the two-way valve may be the cause of this problem.

The image below will help you remove the cabinet and check the pump and two way valve. Remember to unplug the washer first.

The image also shows how to run a drain cycle and the wiring diagram for this washer. The 2nd image shows how to remove the pump if necessarily.

If the washer is no moving any water at all then I suspect the pump is bad and needs to be replaced.

The 3363394 pump is available from the following link: Sears PartsDirect .

I hope this information gives you a start on resolving this problem. You can submit another question with any additional details for further assistance.

Read More
Fred M -
Sears Technician
February 10, 2010

Top Parts