Model #11020052993 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Brake/clutch/gearcase/motor/pump
    3 Results
  • Machine Base
    3 Results
  • Control Panel
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Miscellaneous
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do I change the control board in my Kenmore washer?

A:

In order to access the control board will require placing the console in the service position. See image below. You will need to remove the left (key#8) and right hand (key#11) end cap covers in order to expose the hidden screws. Lift the top of the end cap covers enough to clear the console and hinge the trim cover towards the front of the washer to remove. Remove the screws (key#16) located at the bottom of both end caps (key#7&10). Slide the console forwards and then hinge it over the rear the panel. You now have access to the control board. NOTE: Disconnect the power cord from the power source before placing the console in the service position.

Read More
Joey S -
Sears Technician
November 10, 2009
Q:

What are the specifications for my Kenmore Elite washer model 110.20052993?

A:

This model of Kenmore Elite washer has 3.0 cu. ft. of capacity. It has a 3 speed motor, an ATC (Automatic Temperature Control) system and an electronic control. If you need more or different specifications, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
February 24, 2009
Q:

How do I change the lid switch on my Kenmore Sensor Smart washer?

A:

The following link of a previous answer describes the process for accessing the lid switch in this type of washer: How do I remove the top of my washer to replace the lid switch?

Read More
Lyle W -
Sears Technician
August 12, 2008

Top Parts