Model #11016962501 KENMORE ELITE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts, Miscellaneous Parts, Optional Part
    3 Results
Find part by diagram >

Question and Answers

Q:

washer won't spin 110 16962501

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Julio -
June 10, 2013
A:

Thank You for choosing SearsPartsDirect.com

I can understand your frustration after puting money into fixing your washer and it still doesn't work. Based on the information you have provided I recommend checking the rubber motor coupling. This sits between the clutch and motor, this part can wear down and prevent the washer for going into spin cycle. I have included and image and link below to help you determine if this is the part you need.

Replacement Motor Coupling for Model 110.16962501

If you have further questions please let me know.

Thanks for using SearsPartsDirect.com

 

Read More
Desirea -
Sears Technician
June 12, 2013
A:

The motor coupling is in good shape

Read More
robert -
June 12, 2013
A:

Just so I can clarify, the spin cycle starts, but it stops because of the loud banging?

Read More
Desirea -
Sears Technician
June 13, 2013
A:

The washer works fine until it tries to spin. Then it continually makes a loud banging noise and the tub jerks about 4 to 5 inches. It will continue until the spin cycle is over. I have looked at the motor coupling and it does not have any visual damage. I have replaced the clutch. The braking mechanism appears to be ok. I think it might be something in the transmission. But do not want to open that up until I have exhausted all other solutions.

Read More
robert -
June 13, 2013
A:

Remove the complete agitator so that you can inspect the drive block. Once you remove the agitator put the unit in a spin cycle, let it build up max speed and push the timer knob in to stop the washer. Watch carefully to see if the drive block starts skipping over the top of the tabs of the spin tube. If it is then the drive block needs replacing. Be sure the tabs of the spin tube are not rounded off or it will also need to be replaced. Please message me back with your results.

Read More
Desirea -
Sears Technician
June 13, 2013
See more answers

Top Parts