Model #11014852300 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts
    3 Results
  • Miscellaneous And Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

rubber ring between part number 8533252 and the agitator 11014852300 Kenmore Automatic washer

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your washer. Upon researching model 11014852300; the lock ring on the dispenser cap goes on the bottom of the agitator dispenser cap  part#8533252.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
March 10, 2015
Q:

My washer will not spin or agetate? 11014852300 Kenmore Automatic washer

A:

Thank you for choosing SearsPartsDirect.com. I will be more than happy to assist you.  I can understand any frustration you may have experienced with regards to your unit. Let’s see what we can do for you.

It could be the agitator dogs. Agitator dogs are small cams, located within the top half of the agitator, that control the agitator's movements. The dogs ratchet across the gear teeth in one direction and dig into the gear teeth in the opposite direction to create agitation. If the top half of the agitator spins freely, instead of ratcheting, replace the the agitator dogs.

Hope this information has helped you. If you are not comfortable doing this repair you can click here to schedule a technician or call toll free 1-800-469-4663. If you have any further questions or concerns, you will have to post a new question. Again, thank you for choosing SearsPartsDirect.com.
 

Read More
Samantha A -
Sears Technician
October 02, 2014
Q:

What parts do I need to fix my top load washer?

A:

The part you need to replace the agitator dogs. The part number needed is 80040 and can be purchased from this link. Sears Parts Direct please see the instructions for dog replacement below.I added an image of your agitator below to reference. To access the agitate dogs:

  • Pry the agitator cap off (key#1)
  • Remove the spring retainer (key#14) using the male square end of a 1/2 inch drive ratchet extension. Turn it counterclockwise to remove.
  • Remove the spring (key#18)
  • Lift the augur (key#6) up and turn it upside down *while placing you hand over the top. You now have access to the agitate dogs

Read More
Lyle W -
Sears Technician
November 25, 2009

Top Parts