Model #11014502300 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Brake/clutch/gearcase/motor/pump
    3 Results
  • Machine Base
    3 Results
  • Control Panel
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Miscellaneous
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


How do I remove the agitator from my Kenmore washer?


I referred to your profile and found a washer model 110.14502300. If this is the correct model for your washer these instructions will be correct.

  1. With a small screwdriver pry the agitator cap off the top of the agitator.
  2. Remove the 7/16 bolt just underneath the cap. It is going through a plastic drive block with the dogs on it.
  3. Place your fingers underneath the agitator and lift it off the drive shaft. Don't lift from the center of the agitator or it will come apart and you will have to reassemble it. Lift from the part just above the inner basket of the washer.
  4. Reverse these instructions to reinstall the agitator.

Read More
expert -
Sears Technician
November 07, 2007

Top Parts