Model #1069750614 KENMORE Top-Mount Refrigerator

  • Cabinet
    3 Results
  • Liner
    3 Results
  • Freezer Door
    3 Results
  • Shelf
    3 Results
  • Refrigerator Door
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Capacity of Refrigerator 1069750614 Kenmore Refrigerator

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your refrigerator. Upon researching model 1069750614; based on the model number provided, this unit from 1996 and its 16 cu. Ft.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
June 29, 2015
Q:

icemaker not making ice

A:

I can understand your concern over your ice maker not filling with water. Usually, this issue is caused by a frozen fill tube or a water valve malfunction. I've provided a link below that will discuss these two issues as well as others you might consider. Though this link discusses a different model number, the mechanics are likely going to be very similar. Keep in mind that an expert will be responding within the next two business days if not sooner and will likely offer you more information and instruction. I hope this link will help guide you as to what might be wrong with your ice maker and have a nice day.

Read More
Henry -
July 15, 2013
A:

Sorry, I forgot to add the link.

Read More
Henry -
July 15, 2013
A:

Thank you for submitting your question, I can understand your concern. I will be glad to assist you today. If you hear the solenoid humming when it should be filling the icemaker, you know the icemaker is working. The water valve can hum and not dispense water. The water valve can be bad and cause the symptoms you have. The most common reason icemakers stop filling is because the fill tube in the rear of the icemaker freezes up. Warming the rear of the icemaker for 10 minutes should have melted any ice in the fill tube. I would try turning the refrigerator off and heat the plastic fill tube for 10 minutes with a hair dryer ( Note: not to close to melt plastic) . If the icemaker still doesn't fill with water, I would replace the water valve. The water valve is located on the rear of the cabinet in the compressor compartment. The water line from the house plumbing attaches to the water valve. I am sending you an image showing how to attach the water lines to a new water valve in case you need it. Hope this information is helpful, for additional assistance please reply to the thread below. Thank you for choosing Manage My Life.com.

Read More
Maira -
Sears Technician
July 16, 2013
A:

I don't see the link for the I am having the same problem. I have replaced the icemaker, but still no sound or water. I checked and I am getting power to the unit. Could this still be just a frozen supply line?

Read More
Michael -
July 16, 2013
A:

Michael, Thank you for replying back. If you have not yet checked the back of your refrigerator to verify if the main line is frozen, I do recommend to do so. If the is frozen, with a hair dryer you can defrost it. Be careful not to get to close to the water line if it is a plastic line, can melt the line and cause damage. If the line is fine, and you have already installed a new icemaker, I recommend having a service technician go to your home. To set service you can go to: Sears Home Services. I have attached a link below. Thank you for choosing Manage My Life.com.

Read More
Maira -
Sears Technician
July 18, 2013
See more answers
Q:

Refrigerator leaking water from freezor into fridg

A:

I understand how it can be frustrating with the Refrigerator leaking. I have taken the time to research on the website and have came across similar information towards your issue. While you are waiting for a detailed reply from an expert I have attached the links below. Hope this helps!

Read More
Priscilla V -
February 29, 2012
A:

Thank you for your question. I can understand your concern about the water leaking. Water will leak into the refrigerator when the drain system freezes up. Every time the unit goes into a defrost cycle, water will run down into the refrigerator, instead of down the drain. To clear the drain, remove everything in the freezer, so the back panel can be removed. First disconnect power to the unit. With the panel removed, you will see the evaporator coil and directly under the coil is the drain trough (pan). The trough will probably be full of ice that will need to be removed. A hair dryer works well for this. Just be careful not to get it too hot. With the ice out of the trough, you will be able to see the drain hole, which will be plugged with ice. Use hot water to clear the drain hole. Keep working the hot water into the hole and wiping the excess water. This can take quite awhile, depending on how deep the ice is. This will need to be done until you get a good water flow down to the bottom drain pan. With the drain system clear, water should stop leaking in the refrigerator. If you would like more assistance, reply to this thread and I will be glad to assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Safety Notice: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Scott D -
Sears Technician
March 01, 2012
See more answers

Top Parts