Model #1069750383 KENMORE Top-Mount Refrigerator

  • Cabinet
    3 Results
  • Liner
    3 Results
  • Freezer Door
    3 Results
  • Shelf
    3 Results
  • Refrigerator Door
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Size of Kenmore Coldspot Model 106.9750383.

A:

The cubic feet is important when comparison shopping. I did locate a web link that explains how to calculate the cubic feet. I did check some resources that would put this refrigerator at 20 cu ft. The expert can confirm. If you would like to start the comparison shopping online and take advantage of great sale prices, I attached the link to Sears.com also. I hope this information helps.

Read More
Barbara H. -
June 22, 2012
A:

Thanks! I just found a link on a site for calculating energy savings that indicated my refrigerator was about the size you mention, but I will take measurements as well. Sears is one place I'll check for new frig for sure. Now that I found out my energy company will give me take away the frig and give me $35, I'm in a bit of a better mood about the buying side as well.

Read More
Seth -
June 22, 2012
A:

Thank you for your question. It's nice to know the size of your refrigerator. This will be either a 10 or 20 cubic foot refrigerator. Unless it's a very small fridge, it will be 20 cubic feet. I hope this will help you.

Read More
Scott D -
Sears Technician
June 25, 2012
See more answers
Q:

Broken Ice Maker

A:

I understand that your water inlet valve is not getting any power. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question. Have a great day!

Read More
Alina F. -
June 12, 2012
A:

thanks for that Alina. The valve is good. i am thinking that it is a Switch in the Ice maker or the Wire have gone bad .. May also be a Fuse somewhere but i have not been able to fine one yet. BUt thank again for you help .

Read More
Chris Andrews -
June 12, 2012
A:

Thank you for this question. On the modular icemaker, power is sent to the water valve from the contacts inside the module. I would advise you to check the icemaker power before replacing the icemaker. You sound like you have the tools and knowledge to check the icemaker power. Working with live electrical current can be very hazardous and possibly deadly. Testing voltage output requires working with electrical current. Do not attempt this measurement without the proper tools and safeguards.

The front cover on the icemaker comes off. Inside are some check points labeled L, N, T, H and V. The volts between L and N should equal 120 volts. The icemaker has power to it when 120 are being measured there. Next in the checkout of the module is to get a 12-14 gauge wire about 6 inches long, trim back the insulation on both end. Unplug the refrigerator from the wall outlet. Plug the wire into terminal L and the other end into terminal V. When plugged back into the wall outlet if the valve is working, water will enter the icemaker mold. When you see the water entering the mold, just unplug the refrigerator from the wall and then remove the wire from L to V.

I have sent you a picture of the test and a picture of the module layout. If the icemaker test L to V puts water into the mold, you will need a replacement icemaker. This is the link to the icemaker: Kenmore Refrigerator Model 106.9750083 icemaker . I hope this information is helpful.

Read More
Bill__W -
Sears Technician
June 15, 2012
See more answers

Top Parts