Model #1068253581 KENMORE Upright Freezer

  • Door Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Liner Parts
    3 Results
  • Shelves And Accessories
    3 Results
  • Unit Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Defrost Fan continues to run on upright freezer

A:

When a appliance that you use in a daily basis starts malfunctioning its very frustrating, as a suggestion to help you while you are waiting for the experts advise, I have included below a couple of links to Manage my life were some customers had posted similar questions like yours. Hope it helps!

Read More
Priscilla V -
February 07, 2012
A:

Thank you for your question. I understand your concern about the fan motor. With most of these older freezers, the fan motor will run all the time, except during the defrost cycle. However, this model does show that the fan motor should stop, when the compressor stops. It will need to be determined, if the compressor is cycling off or if it's also running all the time. If the compressor is cycling off and the motor still runs, when the compressor is off, it could be a short in the wiring. I recommend having a technician make this type of check. I'm listing a site you can access, to have a tech come out. Here is a link for the website: Sears Home Services . If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
February 08, 2012
See more answers
Q:

Have an older Kenmore upright freezer that we just purchased used. Manual is no longer available. Keeps alarming on intermittent basis. Any suggestions, please?

A:

Hello, We received your question and we need further time to better assist you. An expert will respond to your question within the next 24 to 48 hours with an accurate answer. Thank You!!!

Read More
Raquel F -
August 16, 2010
A:

The model number that you submitted (106.8253581) appears to be for a freezer with a mechanical thermostat and defrost timer. I don't have technical information or an owner's manual available for this older model. Based on the fact that this freezer has mechanical controls, it is likely that the alarm would be indicating that the door is open. I don't see a door alarm mechanism shown on the parts list diagram. Without technical information or an owner's manual for this model, it is difficult to provide accurate advice. You can unplug the freezer and check for a loose wiring connection on the door switch and the control. This might help. If not, you will likely need to have a service technician physically examine the freezer. Here is a link for the Sears Service website in case you need it: Sears Home Services .

Read More
Lyle W -
Sears Technician
August 17, 2010
See more answers
Q:

Why won't this freezer door close?

A:

Most of the time, the new gasket will have some wrinkles, that need to be smoothed out, after it's been installed on the door. To soften and smooth out the gasket, so it can shape itself to the door, you can use a hair dryer on it. Use it on all the places that are not sealing or on the complete gasket. Be careful not to get the gasket to hot and melt it. If you need more assistance, you can resubmit your question with more details.

Read More
Scott D -
Sears Technician
August 24, 2009

Top Parts