Model #10672204201 KENMORE Top-Mount Refrigerator

  • Cabinet
    3 Results
  • Liner
    3 Results
  • Shelf
    3 Results
  • Refrigerator Door
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
  • Freezer Door
    3 Results
  • Water Dispenser
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

wiring schematic 10672204201 Kenmore Refrigerator

A:

Thank you for choosing SearsPartsDirect.com and for contacting us with your question about your Kenmore refrigerator model 10672204201.  I will be happy to help you with the wiring schematic. I have included an image of it at the bottom of this post. I hope this answers your question. Thank you for choosing Sears, we appreciate your business. 
 

Read More
Rachel Morgan -
Sears Technician
August 12, 2015
A:
Rachel Morgan -
Sears Technician
August 12, 2015
A:

Thank you so much Rachel! You just saved me a lot of time. Have a good one! Mark

Read More
mark -
August 12, 2015
See more answers
Q:

Water leaking under inlet for water/ice maker on back of refrigerator. Do I need to replace with inlet valve part number 2188784? 10672204201

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Henry -
June 23, 2013
A:

I can understand how important it is to have the right parts for your refrigerator. From what you are describing, it does sound like the inlet valve froze during the winter and when re-pressurized it may have cracked. I would recommend that you replace the valve. This is part number 2188784. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
June 25, 2013
See more answers
Q:

Replace refrigerator seal

A:

I understand that you want to replace your door seal. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. I attached the link below for you to view. I hope the link that I provided is helpful. Have a nice day.

Read More
Alina F. -
September 02, 2011
A:

Thank you for your question.

I have looked up the model number you have submitted. The gasket on this refrigerator was original foamed into place. The new gasket has a plastic tab that is pushed in behind the door liner. To replace the gasket you have to pull the old gasket out from behind the inter door liner. Then use a small screwdriver to remove any foam in the channel behind the inter door liner. Once it is cleaned start at the corners and push the plastic tab in behind the inter door liner. After the gasket is fully seated, you can remove the wrinkles in the face of the gasket with a hair dryer. Just be careful not to melt the new gasket. Then close the door and check for gaps. If there are, any gaps heat the gasket with the hair dryer so the gasket will flex into position.

I hope this is helpful. Please let me know if you need further assistance.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
September 04, 2011
See more answers

Top Parts