Model #10672132101 KENMORE Top-Mount Refrigerator

  • Cabinet
    3 Results
  • Liner
    3 Results
  • Freezer Door
    3 Results
  • Shelf
    3 Results
  • Refrigerator Door
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
  • Water Dispenser
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How to wire this new freezer fan motor?

A:

I'm sending you a wire diagram for the motor. There should only be 2 terminals on the motor and it won't matter which one the red and white wires connects to. The green wire is the ground.

Read More
Scott D -
Sears Technician
May 28, 2009
A:

where do I attach the ground wire?

Read More
Robert -
May 20, 2013
See more answers
Q:

Frige is leaking

A:

Joseph - Your appliance was manufactured by Whirlpool. This is a common fault. It could be a problem with the drain from the evaporator or a fault with the defrost system. Let us deal with the cheap and easy fixes and checks first. 1. Check that the refrigerator has a slight 'tip' towards the back, page 10 of the manual at the link below refers. 2. Blow through the drain pipe and be prepared for a load of 'muck' to come out in the refrigerator section. Unless I miss my guess the drain from the evaporator on this model does not go directly to the evaporation pan but drains into the refrigerator section at the top of the back and that is the one you need to check. To access the drain tube remove rear lower back panel, and the lower front grill. Then look up under the refrigerator to find the end of the tube. Then find something, bicycle tire pump, air mattress inflator, or even just a piece of tubing connected to the human mouth, all have been known to work, to get a flow of air up the tube to clear it or ensure it is clear. Please unplug the unit first. Please let us know what you find and we will take it from there. Good Luck.

Read More
biguggy -
April 01, 2012
A:

Thank you for your question. I can understand your concern about the water leak. Water will leak into the refrigerator when the drain system freezes up. Every time the unit goes into a defrost cycle, water will run down into the refrigerator, instead of down the drain. To clear the drain, remove everything in the freezer, so the back panel can be removed. First disconnect power to the unit. With the panel removed, you will see the evaporator coil and directly under the coil is the drain trough (pan). The trough will probably be full of ice that will need to be removed. A hair dryer works well for this. Just be careful not to get it too hot. With the ice out of the trough, you will be able to see the drain hole, which will be plugged with ice. Use hot water to clear the drain hole. Keep working the hot water into the hole and wiping the excess water. This can take quite awhile, depending on how deep the ice is. This will need to be done until you get a good water flow down to the bottom drain pan. It does not drain into the fridge section. With the drain system clear, water should stop leaking in the refrigerator. If you would like more assistance, reply to this thread and I will be glad to assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Safety Notice: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Scott D -
Sears Technician
April 03, 2012
A:

I got the drain unclogged by doing just what you said and it worked perfectly!! Now I just got to figure out why the ice maker isnt work on this fridge. The drain being clogged wouldnt have been a related problem would it?

Read More
joseph -
April 03, 2012
A:

Joseph, I'm glad the drain is working now. This icemaker has some test terminals on the module that may help determine what the problem is. To access the terminals, pull the front cover off of the icemaker. The terminals will be marked (see picture) and using a well insulated jumper, place it between the L - V terminals. Be careful this is a hot (live) check. With the jumper in place, water should flow to the icemaker. If water does flow, the icemaker # 4317943 will need to be replaced. If no water flows but you can hear a humming noise, the water valve # 2188785 will need to be replaced. These parts are available at the link listed below. If nothing at all happens, some voltage checks will need to be made. A technician may be needed to make these checks. You can call 1-800-469-4663 to schedule a tech to come out. If you would like more assistance, I will be glad to assist you further. Thank you for using Manage My Life.

Read More
Scott D -
Sears Technician
April 03, 2012
A:

Ok I did the jumper wire trick and the water started flowing. Is there any way to jump it to make the ice come out cause its full of ice and I now know that since this icemaker isnt working that the ice will just stay in the maker.

Read More
joseph -
April 04, 2012
A:

Joseph, you can jump the T & H terminals to cycle the icemaker. The icemaker will cycle completely and this will eject the ice from the mold. When jumping these 2 terminals, remove the jumper after approx. 10 seconds. I hope this helps you.

Read More
Scott D -
Sears Technician
April 05, 2012
A:

Yes this does thank you.

Read More
joseph -
April 05, 2012
A:

Joseph, thank you for using Manage My Life.

Read More
Scott D -
Sears Technician
April 06, 2012
See more answers
Q:

Kenmore Top Freezer-Refridgerator model 10672132101 water built up inside fridge not evaporation pan

A:

The Refrigerator is one of the most important appliances in the home and by far a must need. So i am understanding your concern over the issue that is currently happening. I have researched your issue on this website and came across a few questions that is similar to yours. The expert provides further detailed information that might enlighten you. Hope this helps!

Read More
Priscilla V -
February 15, 2012
A:

Thank you for your question. I understand your concern about this water leak. The information you received from Priscilla on the first link is correct. I hope it will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
February 16, 2012
See more answers

Top Parts