Model #10671284102 KENMORE Top-Mount Refrigerator

  • Cabinet
    3 Results
  • Liner
    3 Results
  • Shelf
    3 Results
  • Refrigerator Door
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
  • Freezer Door
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Meat Pan Shroud (2200816)

A:

I'm sorry about the difficulties your having with your meat shroud pan. I did some research for you at Managemylife.com and found an expert answer to a similar question that I hope will help until your expert can answer your specific question. I attached the link below. I hope the provided information is useful to you.

Read More
James -
May 17, 2011
A:

I have reviewed the answer you referred too but it pertains to the Meat Pan (2218139). I have that installed. There is another plastic bin that is called a MEAT PAN SHROUD (2200816) and I can't figure out how and where it goes. I have attached an actual picture and in the picture is the SHELF ASSEMBLY (2204989) and beneath that is the open MEAT PAN (2218139). I'm showing the MEAT PAN SHROUD laying on the bottom shelf on an angle.

Read More
Bob -
May 17, 2011
A:

That bin is an accessory that will sit on a shelf to hold meats and cold cuts. It can be placed on any shelf in the refrigerator.

Read More
Lyle W -
Sears Technician
May 19, 2011
See more answers
Q:

leaking refrigerator icemaker

A:

I'm sorry about the difficulties that you are experiencing with your Kenmore refrigerator's ice maker. I did some research at Managemylife.com and found an expert answer to a similar question that may assist you until your expert can respond to your specific question. I have attached the link below. If you decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links will help until your expert can respond.

Read More
James -
April 12, 2011
A:

I can understand your concern. The information you have received from James is good but it pertains to a different type of problem. The most likely reason for this type of leak is, water splashing out of the icemaker fill tube, during the fill cycle. There is an extension # 2203024 for the fill tube, to correct this problem. I'm attaching pictures with instructions, to install this extension. It's available at SearsPartsDirect . Be sure to disconnect power to the unit before making this repair. I hope this will help you. If you would like more assistance, any additional details will be helpful and I will be glad to assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
April 13, 2011
See more answers
Q:

I have a Kenmore refrigerator/freezer with ice maker and autodefrost and it has recently began to drip water from freezer to refrigerator

A:

Hello, I can totally understand how irritating it can be to have a leak in your refrigerator. On pages 19 they have some troubleshooting advice that will probably be very helpful to you. I attached the link below. Hope this helps!!

Read More
Raquel F -
June 30, 2010
A:

When water starts dripping from the freezer into the refrigerator section it most likely from a clogged defrost drain system.

When the defrost system cuts on it will produce a little water that should drain out of the freezer section into a pan below where it will evaporate.

There was also a known issue with ice building up on the left side of the freezer causing water to splash out of the ice maker fill tube.

If there is ice blocking the drain or causing a leak from the fill tube the most effective way of stopping the leak is to let the system defrost.

With the refrigerator turned off you can put the frozen food in the refrigerator section or an ice chest and leave the freezer door open. Once everything melts the drain should be free.

If the problem repeats you may need a fill tube extension to correct the problem but first try just clearing the drain system.

Read More
Fred M -
Sears Technician
July 02, 2010
See more answers

Top Parts