Model #10667292790 KENMORE Top-Mount Refrigerator

  • Cabinet Parts
    3 Results
  • Liner Parts
    3 Results
  • Shelf Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts
    3 Results
  • Freezer Door Parts, Literature And Optional Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Water pooling on shelves

Q:

What is the cubic feet for my Kenmore Model 106.67292790 Refrigerator?

A:

Know specific information on certain appliance is always a must. I did research your question on the web and came across instructions on how to achieve the number.

Read More
celene -
April 19, 2011
A:

Thank you for your question.

I should be able to help you. I have looked up the model number you have submitted. This model is a 22 cubic foot model. Please let me know if you have any other questions.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
April 20, 2011
See more answers
Q:

kenmore frig mod #106.67292790 water is leaking from top down into draws on bottom

A:

kenmore model# 70182000 refrigerator in freezer section the back flow water hose is getting clogged by ice frozen and so the water is leaking back in the refrigerator section so what do i need to replace

Read More
george -
June 07, 2010
A:

I just finished wasting 4 hours unloading a freezer, disassembling it, then putting everything back together following instructions like this. That was not a problem with my unit. The actual fix took way less than 30 minutes. Yes, the freezer drain is plugged, but not as described. The way my unit is set up, the trough and drain hole described by others (as the problem) drain into another plastic trough molded into the top of the fridge section, and this second trough exits through the back of the fridge to a hard plastic pipe. If the pipe is plugged (mine was), the second trough overflows and sends water to the bottom of the fridge. In my case, I had to pull the fridge away from the wall, unscrew one retainer clip near the bottom of the hard pipe, and "unplug" (just pull hard) the rubber connector going into the fridge at the top. The pipe is J-shaped, and the plug was in the curve. I shoved the rubber connector on a garden hose and forced the obstruction out with water.

Read More
Anonymous -
June 07, 2010
A:

Water will leak into the refrigerator when the drain system freezes up. Every time the unit goes into a defrost cycle, water will run down into the refrigerator, instead of down the drain. To clear the drain, remove everything in the freezer so the back panel can be removed. First disconnect power to the unit. With the panel removed, you will see the evaporator coil and directly under the coil is the drain trough (pan). The trough will probably be full of ice that will need to be removed. With the ice out of the trough, you will be able to see the drain hole which will be plugged with ice. Use hot water to clear the drain hole. Keep working the hot water into the hole and wiping the excess water. This can take quite awhile depending on how deep the ice is. This will need to be done until you get a good water flow down to the bottom drain pan. With the drain system clear, water should stop leaking in the refrigerator. If you need more assistance, please resubmit your question, with additional details. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Safety Notice: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Scott D -
Sears Technician
June 09, 2010
See more answers

Top Parts