Model #10664932400 KENMORE Top-Mount Refrigerator

  • Cabinet Parts
    3 Results
  • Liner Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Shelf Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Optional Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Water dripping from freezer into refig 10664932400 Kenmore Top mount refrigerator

A:

Thank you for choosing SearsPartsDirect.com. I will be more than happy to assist you. I can understand any frustration you may have experienced with regards to your unit. Let’s see what we can do for you.

It sounds like the drain inside the freezer for the defrosted water is clogged. I would recommend cleaning out this drain and making sure it’s free of ice and food debris. This can be done using a turkey baster and hot water.

Hope this information has helped you. If you are not comfortable doing this repair you can click here to schedule a technician or call toll free 1-800-469-4663. Again, thank you for choosing SearsPartsDirect.com.

 

Read More
JeffwallaceIII -
Sears Technician
July 21, 2015
Q:

Rear Wheel 10664932400 Kenmore Top mount refrigerator

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Alina -
April 18, 2013
A:

Thank you for your question. Replacing the wheel can be a challenge. First disconnect the power from the unit and close the water supply valve. Next, remove the back panel cover and the water line may need to be disconnected. Now, tilt the unit forward and place a block under the frame. Make sure there is nothing that will leak inside the fridge with it tilted. The rivet holding the wheel will now need to be drilled out on the end and then pull the rivet out. The wheel can now be removed and the new wheel installed. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
April 19, 2013
A:

Revilt will need to be drilled out! So the axel will still be of use, or do I need that also with new wheel? You are talking to a person who has no drill.

Read More
tom -
April 19, 2013
A:

Tom, The rivet (pin) on some of these models may have a tab that can be folded down instead of drilled out, to slide the wheel off. In this case, the rivet can be reused on the new wheel. Then fold the tab back up to hold the wheel in place. If there is not a tab on the end of the rivet and it has to drilled, then a new rivet # 2179826 will need to also be used. I hope this helps you.

Read More
Scott D -
Sears Technician
April 19, 2013
A:

Ok the wheel has been changed. It was much easier then I thought after reading helpful hints and looking on line for other input. How it was done was take cardboard backing off the back bottom of frig, take 2 black bolts that hold bottom plate "back ones" and tilt frig on side opposite of broken rear wheel. Then with just a little lift on side panel using screw driver pull rivet out replace wheel. Done Thanks for help, this sight is great for reference before doing fixes

Read More
tom -
April 25, 2013
A:

Tom, thanks for the information and for using Manage My Life.

Read More
Scott D -
Sears Technician
April 26, 2013
See more answers
Q:

Water Filter Change Frequency at High Altitude


Top Parts