Model #10661192100 KENMORE Top-Mount Refrigerator

  • Cabinet
    3 Results
  • Liner
    3 Results
  • Freezer Door
    3 Results
  • Shelf
    3 Results
  • Refrigerator Door
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

What is the cubic footage of Model 106.61192100? 106.61192100

A:

Thanks for the inquiry and for being a valued member.

Based upon our records for model 106.61192100, we show this unit features 21 cu/ft. of capacity.

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
March 16, 2015
Q:

Can I fix ice build in fridge?

A:

Although most repairs are based on your own comfort level, this problem is a fairly easy job. Below I have posted a couple links that help you understand why your refrigerator is getting ice build up. I hope these linkS are of some assistance.

Read More
Jackie S -
March 04, 2011
A:

Thank you, I will try both these steps and see what happens.

Read More
Carol -
March 04, 2011
A:

I finally got a pic of the leak.

Read More
Carol -
March 04, 2011
A:

If you have an ice maker installed in the freezer, the ice that you are describing is probably caused by splashing out of the fill tube for the ice maker. This situation is described in the image below. The resolution for this problem is to order and install an extension tube over the existing fill tube for the ice maker. The extension tube part number is 2203024. You can order that part from the Sears PartsDirect website.

The installation are instructions for that part are shown in the image below. Be sure that you unplug the refrigerator before accessing internal components.

If you are not completely confident that you can safely install this part on your own, you can have it installed by a service technician. Here is a link for the Sears Service website: Sears Home Services .

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
March 05, 2011
A:

I will check that out thank you very much for your help.

Read More
Carol -
March 05, 2011
See more answers
Q:

Where would I locate a blocked hose to stop the leaking onto the shelves of the fridge?

A:

Water will leak into the refrigerator when the drain system freezes up. Every time the unit goes into a defrost cycle, water will run down into the refrigerator, instead of down the drain. To clear the drain, remove everything in the freezer so the back panel can be removed. First disconnect power to the unit. With the panel removed, you will see the evaporator coil and directly under the coil is the drain trough (pan). The trough will probably be full of ice that will need to be removed. With the ice out of the trough, you will be able to see the drain hole which will be plugged with ice. Use hot water to clear the drain hole. Keep working the hot water into the hole and wiping the excess water. This can take quite awhile depending on how deep the ice is. This will need to be done until you get a good water flow down to the bottom drain pan. With the drain system clear, water should stop leaking in the refrigerator. If you need more assistance, please resubmit your question, with additional details. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Safety Notice: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Scott D -
Sears Technician
April 09, 2010

Top Parts