Model #10658782891 KENMORE Side-by-Side Refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Refrigerator Shelf
    3 Results
  • Freezer Liner
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Air Flow
    3 Results
  • Control
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Hot inside walls 10658782891 Kenmore Refrigerator

A:

Is your coil fan working?

Read More
Vance -
August 13, 2014
A:

Thank you for choosing SearsPartsDirect.com. I will be more than happy to assist you.  I can understand any frustration you may have experienced with regards to your unit. Let’s see what we can do for you.

The condenser & loop system serves two purposes: To transfer/dissipate the heat from the sealed system, into the room. The heat from the yoder loop system is used to transfer heat to the mullion strip, to eliminate moisture and condensation from the strip between the compartments. If the condenser coil is blocked with debris, or the fan doesn't run properly, it does not transfer properly. The first place you, the consumer, will notice it, is the mullion strip or gaskets. I'm sure you'll be fine once you clean the coils, and get a fan motor that runs properly.

Hope this information has helped you. If you are not comfortable doing this repair you can click here to schedule a technician or call toll free 1-800-469-4663. If you have any further questions or concerns, you will have to post a new question. Again, thank you for choosing SearsPartsDirect.com.
 

Read More
Samantha A -
Sears Technician
September 30, 2014
See more answers
Q:

The ice maker no longer works. 10658782891 Kenmore Refrigerator

A:

The ice maker not ejecting the ice can be frustrating. I found some information for you that I am hoping will be able to help you. I am adding the link below to help you with your question while you wait for your expert response. It may take two business days for your expert to respond. I do hope that this will help you.

Read More
Marc -
February 11, 2013
A:

I don't see a link anywhere. Thanks.

Read More
Matt -
February 11, 2013
A:

Thank you for posting your question on ManageMyLife.com

There are some test terminals, on this icemaker module that may help determine the problem. To access the module, just pull the front cover, off of the icemaker. You will now be able to see the module and the test terminals will be marked (I'm sending you a picture). Insert a well insulated jumper into the T-H terminals. Be careful this is a hot (live) check. With the jumper in place, the icemaker should start into a cycle. When the icemaker starts, remove the jumper after approximately 5 seconds. If the icemaker cycles completely, ejects the ice and refills, the icemaker # 4317943 will need to be replaced. If the icemaker does not cycle some voltage checks will need to be made. A volt/ohm meter will be needed. If you need more assistance, you can resubmit your question with more details.

Read More
Desirea -
Sears Technician
February 11, 2013
See more answers

Top Parts