Model #10658722801 KENMORE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Refrigerator Shelf Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Control lights do not come back on after restart, everything else seems to work properly 10658722801 Kenmore Side-by-side refrigerator

A:

Thank you for choosing SearsPartsDirect.com. I will be more then happy to assist you. Looking at the information I'm showing that main issue could be the control board. The control board is located at the top inside the fridge. Its were the control lights are located. I would recommend replacing that part. The part number for that control is 4388932. Hope this information has help you. If you are not comfortable doing this repair you can Click Here to schedule a technician or call toll free 1-800-469-4663. Any further questions or concerns. You will have to post a new question because at this time I can not reply to any comments. Again, Thank you for choosing SearsPartsDirect.com.

Read More
Samantha A -
Sears Technician
June 18, 2014
Q:

I have a side by side Kenmore refrigerator. I bought it in nov 2012 from Sears and I don't have a warranty no more.

A:

I am sorry that you are having some difficulties with your ice maker and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your ice maker troubles while you wait for your expert response.

Read More
Joseph P. -
September 15, 2012
A:

Thank you for your question. I know it can be disappointing when the icemaker stops working. The information you have received is very good. The icemaker in this model can stop working for a few reasons. Some are listed below:

  • The icemaker itself can fail
  • The water valve may not open
  • The optic boards can fail
  • The fill tube can freeze up
  • Freezer temperature not cold enough (should be 0 � 5 degrees)
The blinking led light can be flashing a code that will indicate the problem. If it flashes 2 times pauses and continues this while the door is open, it will be normal and if it stays on continuous, when the flapper door on the left side is held in, it indicates the boards are ok. I�m attaching a chart for the led indicator. When checking this icemaker, tape the little flapper door shut and disconnect power to the refrigerator. To check this icemaker, slide it out, so the front cover can be removed, to access some test terminals. There is a clip located on the back right corner of the icemaker that will need to be removed, to slide the icemaker out. There will be a screw at the bottom of the clip holding it. I�m sending a picture with instructions to remove this clip. With the clip removed, slide the icemaker out and remove the front cover. You will now see the test terminals, which are marked (see picture). Now remove the 3 screws holding the receiver board on the right side pull the board out and disconnect the harness from the board. Place a jumper between the black and black/white wires (see picture). Now use a second jumper and place it between the L � V terminals on the module. Reconnect the power and with both jumpers in place, water should now flow to the icemaker (be prepared to catch water from the fill tube). If water does flow, the icemaker # 2198597 will need to be replaced. If no water flows but you can hear a humming noise, the water valve # W10408179 will need to be replaced. If nothing at all happens, some voltage checks will need to be made. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

If you do not feel confident repairing this problem or doing any voltage checks yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services . If you need more assistance additional details will be helpful.

Safety Notice: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Scott D -
Sears Technician
September 17, 2012
See more answers
Q:

my side by side,which i bought in dec of 08 has never dispenced ice from the door. it stays frozen with a block of ice

A:

Managemylife.com is a great place to find the answers to just about anything, especially on appliances. I would suggest that you provide a little more information such as the make and complete model number of your product so your expert will be able to provide you the best possible answer. Just click on reply below where you can provide the additional information.

Read More
Priscilla V -
November 29, 2011
A:

my side by side,which i bought in dec of 08 has never dispenced ice from the door. it stays frozen with a block of ice 10658722801

Read More
krista butts -
November 29, 2011
A:

Thank you for your question. I know it's disappointing when the ice dispenser stops working. First, make sure the chute door is making a good seal. If there is any air leakage, it will cause this problem. A good check is to, shine a flashlight inside the chute and check the outside, to see if you can see any light. If you do see some light, the door mechanism # 8201649 may need to be replaced.

The most common problem associated with this type of ice dispenser will be ice fusing in the bucket and forming a solid block. It's normal for ice to fuse together in all ice buckets but it will happen at a faster rate when the bucket is in the door. Every time the door is opened, the bucket is out of the freezer, so it will speed up this process. To help prevent this from happening, a lot of ice will need to be used often or periodically, the bucket will need to be emptied. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
December 01, 2011
See more answers

Top Parts