Model #10658502800 KENMORE Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Refrigerator Shelf Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Unit Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Icemaker Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

water dispensor 10658502800 Kenmore Side-by-side refrigerator

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your refrigerator and I do understand your frustration. Glad to help out. I'm looking at your model number 10658502800 and It sounds like the water valve is not completely shutting off and may need to be replaced. Before you replace the water valve remove the crisper drawers and locate the chilled water reservoir behind them and check to see if you have an air bubble in the tank. If you do, many times this will cause the dripping faucet type effect from the air bubble moving in the tank. See if you can do a long purge of the water line by using a 2 quart container and running the water valve for at least a minute to see if you can get the bubble to purge out of the tank. There is natural air in water and sometimes it will collet and build up in the tank. The new refrigerators have gone to a roll of plastic tubing instead of the tank style to prevent this problem. If you have you air in the tank then I would think the replacement of the water valve is necessary. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
October 31, 2014
Q:

fan runs constantly 10658502800 Kenmore Side-by-side refrigerator

A:

Thank You for choosing Sears PartsDirect.com. It is unfortunate to hear that you are having issues with your fridge and I do understand your frustration. Glad to help out. I'm looking at your model number 10658502800 and if the fan motor is running constantly, this could be a problem with the thermostat. If it's stuck closed, the unit will run all the time and could be getting excessively cold, which could also be a factor in the icing condition. In this case, adjust the thermostat to a warmer setting to see if the unit starts cycling. If it cycles now and if it stops icing, you can leave the thermostat where it’s set.

If the problem still occurs, the problem could be with the fridge section not getting cold enough, causing the thermostat to stay engaged. This would relate back to the defrost system. In this case, as the frost builds, it reduces air flow to the fridge, causing a cooling problem. A good check for this will be to manually advance it into a defrost cycle. To advance this control, the following must be done in the order as listed.

Disconnect the power

Turn the thermostat off and leave it off

Reconnect the power

After a few minutes, if you can hear a sizzling or popping sound inside the freezer, it means the heating element is working. In this case, the thermostat or the bi metal defrost  will need to be replaced. The fridge has 2 fans, one in the freezer section and one in the bottom near the evaporator.  I hope this information helps with your troubleshooting and if you have further questions please resubmit your question for further information.
 
Thank you for choosing Sears PartsDirect.com.

Read More
Sherman_G_Wallace -
Sears Technician
July 16, 2014
Q:

How to remove cover over controls for ice maker? 10658502800 Kenmore Side-by-side refrigerator

A:

Thank you for choosing Sears Parts Direct. I can certainly understand how frustrating it can be when needing to remove the cover on your Refrigerator. I did look into the model number you have provided and I have found information that will assist you in the replacement of that chute.

 

Normally the dispenser cover (key#21) will have to be slid upwards until it stops and then pull the top of the trim outwards and off. It could break if care is not taken when sliding it upwards so that it can release from the bottom 2 cradles. The control bracket (key#15) will need to be removed by removing the 2 screws (key#22) in order to gain access to the ice door (key#6).

 Thank you for your question. Have a great day.

Read More
Natasha12 -
Sears Technician
October 21, 2013

Top Parts